Re: [PATCH v5 5/6] arm64: dts: qcom: Add support for QCS9075 Ride & Ride-r3

[Wasim Nazir]

On Tue, Dec 31, 2024 at 06:10:15AM +0100, Andrew Lunn wrote:
> > > +&ethernet0 {
> > > +	phy-mode = "2500base-x";
> > > +};
> > > +
> > > +&ethernet1 {
> > > +	phy-mode = "2500base-x";
> > > +};
> > > +
> > > +&mdio {
> > > +	compatible = "snps,dwmac-mdio";
> > > +	#address-cells = <1>;
> > > +	#size-cells = <0>;
> > > +
> > > +	sgmii_phy0: phy@8 {
> > > +		compatible = "ethernet-phy-id31c3.1c33";
> > > +		reg = <0x8>;
> > > +		device_type = "ethernet-phy";
> > > +		interrupts-extended = <&tlmm 7 IRQ_TYPE_EDGE_FALLING>;
> > > +		reset-gpios = <&pmm8654au_2_gpios 8 GPIO_ACTIVE_LOW>;
> > > +		reset-assert-us = <11000>;
> > > +		reset-deassert-us = <70000>;
> > > +	};
> > > +
> > > +	sgmii_phy1: phy@0 {
> 
> SGMII is 10/100/1000. You have a phy-mode of 2500base-x, which is only
> 2500. So calling this sgmii_phy is wrong. Just call it phy1: phy@0.
> 

Thanks Konrad/Andrew will fix this in next patch.

Regards,
Wasim