Re: [RESEND PATCH v5 0/4] Add Synopsys DesignWare HDMI RX Controller

[Tim Surber]

Hi Dmitry,

that was my fault, my build script did not copy over the new ATF properly.

Now it works, I will update with test results with many different 
resolutions/formats here soon.

Best regards,
Tim


On 1/6/25 12:22, Dmitry Osipenko wrote:
> Hi,
>
> On 1/6/25 03:16, Tim Surber wrote:
> > I applied your patch to rockchip/next on an FriendlyElec CM3588 device with arm-
> > trusted-firmware 2.12. This is the same hardware/cable/sources I used previously
> > Sadly I could not get it to work at all.
> >
> > After connection to a HDMI source I get the following error with all devices and
> > resolutions I tested
> > # dmesg
> > snps_hdmirx fdee0000.hdmi_receiver: hdmirx_controller_init wait timer base lock
> > failed
> > snps_hdmirx fdee0000.hdmi_receiver: hdmirx_phy_register_write wait cr write done
> > failed (repeating multiple times)
>
> Sounds like interrupt may be not working for you. Interrupt won't work
> using downstream version of AT-F, though I assume you're using vanilla
> version of the AT-F. Could you please show output of `cat
> /proc/interrupts | grep rk_hdmirx` after plugging the HDMI cable.