[PATCH v2 1/2] dt-bindings: hwmon: ti,ina2xx: Add INA233 device

[Leo Yang]

Add TI INA233 Current and Power Monitor bindings.

Signed-off-by: Leo Yang <Leo-Yang@xxxxxxxxxxxx>
---
 .../devicetree/bindings/hwmon/ti,ina2xx.yaml    | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
index 05a9cb36cd82..9759c69b904b 100644
--- a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
+++ b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
@@ -27,6 +27,7 @@ properties:
       - ti,ina226
       - ti,ina230
       - ti,ina231
+      - ti,ina233
       - ti,ina237
       - ti,ina238
       - ti,ina260
@@ -75,6 +76,22 @@ properties:
       the alert polarity to active-high.
     $ref: /schemas/types.yaml#/definitions/flag
 
+  ti,current-lsb:
+    description:
+      This value depends on the maximum current that can be expected to be
+      measured by ina233 in your circuit, divide Maximum Expected Current
+      by 2^15 and express it in microamps.
+
+      This value will be used to calculate the current/power coefficient for
+      the pmbus and to calibrate the IC.
+
+      For device INA233.
+
+      e.g. Calculate the Maximum Expected Current(A) / 2^15 in micro ampere (uA).
+      30A / 2^15 = 915 uA
+      If value is close to 1000 uA, can use 1000 uA to minimize rounding errors.
+    $ref: /schemas/types.yaml#/definitions/uint16
+
 required:
   - compatible
   - reg
-- 
2.39.2