Re: [PATCH net-next 2/2] net: phy: dp83822: Add support for changing the transmit amplitude voltage

[Simon Horman]

On Mon, Jan 13, 2025 at 06:40:13AM +0100, Dimitri Fedrau via B4 Relay wrote:
> From: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx>
> 
> Add support for changing the transmit amplitude voltage in 100BASE-TX mode.
> Add support for configuration via DT.
> 
> Signed-off-by: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx>
> ---
>  drivers/net/phy/dp83822.c | 35 +++++++++++++++++++++++++++++++++++
>  1 file changed, 35 insertions(+)
> 
> diff --git a/drivers/net/phy/dp83822.c b/drivers/net/phy/dp83822.c

...

> @@ -197,6 +201,12 @@ struct dp83822_private {
>  	bool set_gpio2_clk_out;
>  	u32 gpio2_clk_out;
>  	bool led_pin_enable[DP83822_MAX_LED_PINS];
> +	int tx_amplitude_100base_tx_index;
> +};
> +
> +static const u32 tx_amplitude_100base_tx[] = {
> +	1600, 1633, 1667, 1700, 1733, 1767, 1800, 1833,
> +	1867, 1900, 1933, 1967, 2000, 2033, 2067, 2100,
>  };
>  

nit: The use of tx_amplitude_100base_tx seems to be protected by
     #ifdef CONFIG_OF_MDIO, so the definition of tx_amplitude_100base_tx
     probably should be too.

     Flagged by W=1 allmodconfig builds.

...