Re: [RFC PATCH 02/10] net: ti: prueth: Adds ICSSM Ethernet driver

[Basharath Hussain Khaja]

>> +	emac->phy_node = of_parse_phandle(eth_node, "phy-handle", 0);
>> +	if (!emac->phy_node) {
>> +		dev_err(prueth->dev, "couldn't find phy-handle\n");
>> +		ret = -ENODEV;
>> +		goto free;
>> +	}
>> +
>> +	ret = of_get_phy_mode(eth_node, &emac->phy_if);
>> +	if (ret) {
>> +		dev_err(prueth->dev, "could not get phy-mode property err %d\n",
>> +			ret);
>> +		goto free;
>> +	}
>> +
>> +	/* connect PHY */
>> +	emac->phydev = of_phy_connect(ndev, emac->phy_node,
>> +				      &icssm_emac_adjust_link, 0, emac->phy_if);
>> +	if (!emac->phydev) {
>> +		dev_dbg(prueth->dev, "couldn't connect to phy %s\n",
>> +			emac->phy_node->full_name);
>> +		ret = -EPROBE_DEFER;
>> +		goto free;
>> +	}
> 
> of_phy_get_and_connect() will simplify this.
> 

Yes. This API does same functionality, we will replace three APIs with single 
API in the next version.

>> +	/* remove unsupported modes */
>> +	phy_remove_link_mode(emac->phydev, ETHTOOL_LINK_MODE_10baseT_Half_BIT);
>> +	phy_remove_link_mode(emac->phydev, ETHTOOL_LINK_MODE_10baseT_Full_BIT);
> 
> It only does 100Mbps?
> 

It is capable of both 100M/10M full/half-duplex modes. In this patch series we are 
adding support for 100M full duplex operation. Support for other modes will be added 
subsequently.

>> +	if (of_property_read_bool(eth_node, "ti,no-half-duplex")) {
> 
> Is this becasue 100baseT_Half is broken in some versions of the
> hardware?
> 

No.This property will be removed as we have added support only for 100M full duplex.
 
>> +		phy_remove_link_mode(emac->phydev,
>> +				     ETHTOOL_LINK_MODE_100baseT_Half_BIT);
>> +	}
>> +
>> +	phy_remove_link_mode(emac->phydev, ETHTOOL_LINK_MODE_Pause_BIT);
>> +	phy_remove_link_mode(emac->phydev, ETHTOOL_LINK_MODE_Asym_Pause_BIT);
> 
> Is this really needed? I've not checked, but if you don't call
> phy_support_sym_pause() or phy_support_asym_pause(), i would of
> expected phylib to default to no pause?
>
 
Though TI PHY default state is clear(ASM_DIR - 0 & PAUSE - 0 as Default
state in ANAR register), this bits are cleared again to handle if in case 
of change in PHY.

>> +static const struct of_device_id prueth_dt_match[];
> 
> Please avoid forward references. If you need the match table, define
> it here.
>
 
Sure. This got escaped while cleanup. We will address this in the next version.

Thanks & Best Regards,
Basharath