Re: [PATCH v4 2/4] dt-bindings: mfd: Add MDIO interface to rtl9301-switch

[Krzysztof Kozlowski]

On 22/01/2025 21:53, Chris Packham wrote:
>>>         };
>>> +
>>> +      mdio-controller {
>> No, no resources here, no unit address. Look at other nodes - they have
>> the resource, the address. Mixing such nodes is clear indication this is
>> not correct hardware description and you do this only for Linux.
>>
>> Fold child device into parent.
> 
> In this particular case all the mdio stuff is actually contained to a 
> range starting at offset 0xca00. I dropped it because it was simpler in 
> the driver to use the full 16-bit address rather than trying to use 
> offsets from the base address that didn't correspond to the datasheet. 
> As you've highlighted that's making the dt-binding impose driver 
> specifics so would adding back `mdio-controller@ca00` and `reg = <0xca00 
> 0x200>;` be OK even if the driver doesn't actually use them?


If this matches the hardware, then yes.

Best regards,
Krzysztof