[PATCH] clk: sunxi: clean up rate counting

[Anastasia Belova]

If n = 255, the result of multiplication of n and 24000000
may not fit int type. Swap division and shift with multiplication.

Found by Linux Verification Center (linuxtesting.org) with SVACE.

Fixes: 6424e0aeebc4 ("clk: sunxi: rewrite sun9i_a80_get_pll4_factors()")
Signed-off-by: Anastasia Belova <abelova@xxxxxxxxxxxxx>
---
 drivers/clk/sunxi/clk-sun9i-core.c | 14 +++++++++-----
 1 file changed, 9 insertions(+), 5 deletions(-)

diff --git a/drivers/clk/sunxi/clk-sun9i-core.c b/drivers/clk/sunxi/clk-sun9i-core.c
index d93c7a53c6c0..639c83ed63b8 100644
--- a/drivers/clk/sunxi/clk-sun9i-core.c
+++ b/drivers/clk/sunxi/clk-sun9i-core.c
@@ -25,12 +25,12 @@
 
 static void sun9i_a80_get_pll4_factors(struct factors_request *req)
 {
-	int n;
-	int m = 1;
-	int p = 1;
+	unsigned int n;
+	unsigned int m = 1;
+	unsigned int p = 1;
 
 	/* Normalize value to a 6 MHz multiple (24 MHz / 4) */
-	n = DIV_ROUND_UP(req->rate, 6000000);
+	n = DIV_ROUND_UP(req->rate, 6000000ul);
 
 	/* If n is too large switch to steps of 12 MHz */
 	if (n > 255) {
@@ -50,7 +50,11 @@ static void sun9i_a80_get_pll4_factors(struct factors_request *req)
 	else if (n < 12)
 		n = 12;
 
-	req->rate = ((24000000 * n) >> p) / (m + 1);
+	/* Division and shift should be done before multiplication to
+	 * avoid overflow. The result will be correct because '>> p' and
+	 * '/ (m + 1)' are both just conditional 'divide by 2'
+	 */
+	req->rate = ((24000000ul >> p) / (m + 1)) * n;
 	req->n = n;
 	req->m = m;
 	req->p = p;
-- 
2.43.0