[PATCH v2 2/2] wifi: mwifiex: Fix HT40 bandwidth issue.

[Jeff Chen]

This patch addresses an issue where, despite the AP supporting 40MHz
bandwidth, the connection was limited to 20MHz. Without this fix,
even if the access point supports 40MHz, the bandwidth after
connection remains at 20MHz. This issue is not a regression.

Signed-off-by: Jeff Chen <jeff.chen_1@xxxxxxx>
---
 drivers/net/wireless/marvell/mwifiex/11n.c | 18 ++++++++++--------
 1 file changed, 10 insertions(+), 8 deletions(-)

diff --git a/drivers/net/wireless/marvell/mwifiex/11n.c b/drivers/net/wireless/marvell/mwifiex/11n.c
index 66f0f5377ac1..4ae0b4aaa09a 100644
--- a/drivers/net/wireless/marvell/mwifiex/11n.c
+++ b/drivers/net/wireless/marvell/mwifiex/11n.c
@@ -308,7 +308,7 @@ mwifiex_cmd_append_11n_tlv(struct mwifiex_private *priv,
 	int ret_len = 0;
 	struct ieee80211_supported_band *sband;
 	struct ieee_types_header *hdr;
-	u8 radio_type;
+	u8 radio_type, secch_offset;
 
 	if (!buffer || !*buffer)
 		return ret_len;
@@ -401,13 +401,15 @@ mwifiex_cmd_append_11n_tlv(struct mwifiex_private *priv,
 		chan_list->chan_scan_param[0].radio_type =
 			mwifiex_band_to_radio_type((u8) bss_desc->bss_band);
 
-		if (sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40 &&
-		    bss_desc->bcn_ht_oper->ht_param &
-		    IEEE80211_HT_PARAM_CHAN_WIDTH_ANY)
-			SET_SECONDARYCHAN(chan_list->chan_scan_param[0].
-					  radio_type,
-					  (bss_desc->bcn_ht_oper->ht_param &
-					  IEEE80211_HT_PARAM_CHA_SEC_OFFSET));
+		if (sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40) {
+			if (bss_desc->bcn_ht_oper->ht_param & IEEE80211_HT_PARAM_CHAN_WIDTH_ANY) {
+				chan_list->chan_scan_param[0].radio_type |= (CHAN_BW_40MHZ << 2);
+				secch_offset = bss_desc->bcn_ht_oper->ht_param &
+				IEEE80211_HT_PARAM_CHA_SEC_OFFSET;
+				SET_SECONDARYCHAN(chan_list->chan_scan_param[0].radio_type,
+						  secch_offset);
+			}
+		}
 
 		*buffer += struct_size(chan_list, chan_scan_param, 1);
 		ret_len += struct_size(chan_list, chan_scan_param, 1);
-- 
2.34.1