Re: [PATCH] genirq: clear IRQS_PENDING in irq descriptor

[Thomas Gleixner]

On Tue, Feb 11 2025 at 10:30, Bo Ye wrote:
> In the kernel-6.6 IRQ subsystem, there is a case of IRQ retrigger:

How is kernel 6.6 relevant here?

> Due to the possibility of electrical signal glitches causing false
> interrupts for edge-triggered type IRQs, it is necessary to clear any
> potential false interrupts or re-triggered interrupt signals from the
> interrupt source between disabling and enabling the edge-triggered
> IRQ.

This claim is just wrong.

A disable_irq(); enable_irq(); sequence must preserve the pending bit so
that interrupts do not get lost. The lazy disabling mechanism is there
to guarantee that.

> When the module using this IRQ may disable the IRQ as needed and then
> If the disabled IRQ is triggered, the IRQ subsystem will set the
> istate of the corresponding IRQ descriptor to pending.

Rightfully so.

> After the module using this IRQ completes other tasks, it clears the
> pending state on the GIC using irq_set_irqchip_state().

So this is a problem related to a specific out of tree driver and the
GIC, right? 

> However, the pending state in the IRQ descriptor's istate is not
> cleared, which leads to the module receiving the IRQ again after
> enabling it, even though the interrupt source has not triggered,
> because the IRQ subsystem retriggers the interrupt based on the
> pending state in the IRQ descriptor.

What's the actual problem here? A driver has to be able to handle
spurious interrupts at any given time.

> Solution: the corresponding upstream patch modifies the
> irq_set_irqchip_state(...) in the IRQ subsystem.

Which corresponding upstream patch?

> The purpose is to clear the pending state in the IRQ descriptor's
> istate when successfully clearing the corresponding IRQ on the GIC.

Sure that's the purpose, but you fail to explain the actual problem and
the interaction with irq_set_irqchip_state().

Thanks,

        tglx