[PATCH 1/2] arm64: dts: imx8mm: Add pinctrl config definitions

[Maud Spierings via B4 Relay]

From: Maud Spierings <maudspierings@xxxxxxxxxxxxxx>

Currently to configure each IOMUXC_SW_PAD_CTL_PAD the raw value of this
register is written in the dts, these values are not obvious. Add defines
which describe the fields of this register which can be or-ed together to
produce readable settings.

Signed-off-by: Maud Spierings <maudspierings@xxxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/freescale/imx8mm-pinfunc.h | 27 ++++++++++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-pinfunc.h b/arch/arm64/boot/dts/freescale/imx8mm-pinfunc.h
index b1f11098d248ed5fc8ac42daed808beebe3bf7bc..b231d5968d07d1e135963b714c3fe80ddd8641ab 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-pinfunc.h
+++ b/arch/arm64/boot/dts/freescale/imx8mm-pinfunc.h
@@ -6,6 +6,33 @@
 #ifndef __DTS_IMX8MM_PINFUNC_H
 #define __DTS_IMX8MM_PINFUNC_H
 
+//Drive Strength
+#define MX8MM_DSE_X1 0x0
+#define MX8MM_DSE_X2 0x4
+#define MX8MM_DSE_X4 0x2
+#define MX8MM_DSE_X6 0x6
+
+//Slew Rate
+#define MX8MM_FSEL_FAST 0x10
+#define MX8MM_FSEL_SLOW 0x0
+
+//Open Drain
+#define MX8MM_ODE_ENABLE 0x20
+#define MX8MM_ODE_DISABLE 0x0
+
+#define MX8MM_PULL_DOWN 0x0
+#define MX8MM_PULL_UP 0x40
+
+//Hysteresis
+#define MX8MM_HYS_CMOS 0x0
+#define MX8MM_HYS_SCHMITT 0x80
+
+#define MX8MM_PULL_ENABLE 0x100
+#define MX8MM_PULL_DISABLE 0x0
+
+//?
+#define MX8MM_MYSTERY_BIT 0x40000000
+
 /*
  * The pin function ID is a tuple of
  * <mux_reg conf_reg input_reg mux_mode input_val>

-- 
2.48.1