Re: [PATCH net-next v2 2/2] net: phy: marvell-88q2xxx: Prevent hwmon access with asserted reset

[Russell King (Oracle)]

On Thu, Feb 20, 2025 at 04:22:14PM +0100, Dimitri Fedrau wrote:
> Hi Russell,
> 
> Am Thu, Feb 20, 2025 at 09:36:49AM +0000 schrieb Russell King (Oracle):
> > On Thu, Feb 20, 2025 at 09:11:12AM +0100, Dimitri Fedrau wrote:
> > > If the PHYs reset is asserted it returns 0xffff for any read operation.
> > > This might happen if the user admins down the interface and wants to read
> > > the temperature. Prevent reading the temperature in this case and return
> > > with an network is down error. Write operations are ignored by the device
> > > when reset is asserted, still return a network is down error in this
> > > case to make the user aware of the operation gone wrong.
> > 
> > If we look at where mdio_device_reset() is called from:
> > 
> > 1. mdio_device_register() -> mdiobus_register_device() asserts reset
> >    before adding the device to the device layer (which will then
> >    cause the driver to be searched for and bound.)
> > 
> > 2. mdio_probe(), deasserts the reset signal before calling the MDIO
> >    driver's ->probe method, which will be phy_probe().
> > 
> > 3. after a probe failure to re-assert the reset signal.
> > 
> > 4. after ->remove has been called.
> > 
> 
> There is also phy_device_reset that calls mdio_device_reset.

Ok, thanks for pointing that out.

> > That is the sum total. So, while the driver is bound to the device,
> > phydev->mdio.reset_state is guaranteed to be zero.
> > 
> > Therefore, is this patch fixing a real observed problem with the
> > current driver?
> >
> Yes, when I admin up and afterwards down the network device then the PHYs
> reset is asserted. In this case phy_detach is called which calls
> phy_device_reset(phydev, 1), ...

I'm still concerned that this solution is basically racy - the
netdev can come up/down while hwmon is accessing the device. I'm
also unconvinced that ENETDOWN is a good idea here.

While I get the "describe the hardware" is there a real benefit to
describing this?

What I'm wondering is whether manipulating the reset signal in this
case provides more pain than gain.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!