Re: [PATCH v4 3/3] arm64: dts: imx: add imx95 dts for sof

[Laurentiu Mihalcea]

On 2/24/2025 9:51 PM, Frank Li wrote:
> On Mon, Feb 24, 2025 at 09:17:03PM +0200, Mihalcea Laurentiu wrote:
>> On 12.02.2025 01:23, Frank Li wrote:
>>> On Tue, Feb 11, 2025 at 05:58:08PM -0500, Laurentiu Mihalcea wrote:
>>>> From: Laurentiu Mihalcea <laurentiu.mihalcea@xxxxxxx>
>>>>
>>>> Add imx95 DTS for SOF usage.
>>>>
>>>> Signed-off-by: Laurentiu Mihalcea <laurentiu.mihalcea@xxxxxxx>
>>>> ---
>>>>  arch/arm64/boot/dts/freescale/Makefile        |  1 +
>>>>  .../dts/freescale/imx95-19x19-evk-sof.dts     | 85 +++++++++++++++++++
>>>>  2 files changed, 86 insertions(+)
>>>>  create mode 100644 arch/arm64/boot/dts/freescale/imx95-19x19-evk-sof.dts
>>>>
>>>> diff --git a/arch/arm64/boot/dts/freescale/Makefile b/arch/arm64/boot/dts/freescale/Makefile
>>>> index 839432153cc7..27f64e333e4b 100644
>>>> --- a/arch/arm64/boot/dts/freescale/Makefile
>>>> +++ b/arch/arm64/boot/dts/freescale/Makefile
>>>> @@ -282,6 +282,7 @@ dtb-$(CONFIG_ARCH_MXC) += imx93-tqma9352-mba93xxca.dtb
>>>>  dtb-$(CONFIG_ARCH_MXC) += imx93-tqma9352-mba93xxla.dtb
>>>>  dtb-$(CONFIG_ARCH_MXC) += imx93-var-som-symphony.dtb
>>>>  dtb-$(CONFIG_ARCH_MXC) += imx95-19x19-evk.dtb
>>>> +dtb-$(CONFIG_ARCH_MXC) += imx95-19x19-evk-sof.dtb
>>> look like should use dt overlay ?
>>
>> can you pls explain why you'd see this as an overlay?
> It is addtional option, which base on imx95-19x19-evk.dtb. Default wm8962
> is used for built-in dai, this provide option to move it dsp.
>
> Ideally this option should work for all boards, which use wm8962.
>
> We try to move MxN problem to M + N. otherwise, there are huge numbers of
> dtb files.
>
> Frank

Yeah but these are not cameras/sensors (for which there's a lot of possible combinations)
we're dealing with. Unless your board has the same codec, same GPIO for headphone
detection, and uses the same SAI instance this overlay will not work. For instance,
this wouldn't work for the imx95 15x15 EVK board as that uses a different GPIO for
headphone detection. As such, you'll most likely end up with a different DT overlay for
each board instead of a DTB.

Also, from the experience with the IMX8 series, we really don't have many DTBs. Usually,
it's been 1 for the base board and 1 for the audio board if applicable (which can probably
be turned into DT overlays. It would certainly make more sense this way).


Given all this, I'm still not convinced that DT overlays are the way to go.