RE: [PATCH v2] USB: serial: ftdi_sio: add support for Altera USB Blaster 3

[Ng, Boon Khai]

> But for your future contributions, remember to put a short changelog here
> under the cut-off (---) line when revising patches.

My apology will include that next time.

> 
> These configurations were not mentioned in the commit message. Are they
> also used for embedded designs?

Looks like the table I provided in the commit message is mismatched with 
the one that I intended to check in for upstream.

Let me correct this, the one that I published for upstream was the actual tested
code, whereby we want the UART to be exposed to the ftdi_sio driver.

Below is the updated table, 
1) PID 0x6022, FT2232, 1 JTAG port(Port A) + Port B as UART
2) PID 0x6025, FT4232, 1 JTAG port(Port A) + Port C as UART
3) PID 0x6026, FT4232, 1 JTAG port(Port A) + Port C, D as UART
4) PID 0x6029, FT4232, 1 JTAG port(Port B) + Port C as UART
5) PID 0x602a, FT4232, 1 JTAG port(Port B) + Port C, D as UART
6) PID 0x602c, FT4232, 1 JTAG port(Port A) + Port B as UART
7) PID 0x602d, FT4232, 1 JTAG port(Port A) + Port B, C as UART
8) PID 0x602e, FT4232, 1 JTAG port(Port A) + Port B, C, D as UART

Since we need UART to be exposed to the ftdi_sio driver and the cable USB Blaster
does not support UART, will reword that on the commit message to remove the 
cable USB Blaster and left only the on-board USB Blaster.

Will submit a v3 on this, with the reworded commit message plus the change log.