Re: [PATCH v4 02/10] arm64: dts: qcom: qcs6490-rb3gen2: Add TC956x PCIe switch node

[Dmitry Baryshkov]

On Tue, Feb 25, 2025 at 03:03:59PM +0530, Krishna Chaitanya Chundru wrote:
> Add a node for the TC956x PCIe switch, which has three downstream ports.
> Two embedded Ethernet devices are present on one of the downstream ports.
> 
> Power to the TC956x is supplied through two LDO regulators, controlled by
> two GPIOs, which are added as fixed regulators. Configure the TC956x
> through I2C.
> 
> Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@xxxxxxxxxxxxxxxx>
> Reviewed-by: Bjorn Andersson <andersson@xxxxxxxxxx>
> Acked-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 116 +++++++++++++++++++++++++++
>  arch/arm64/boot/dts/qcom/sc7280.dtsi         |   2 +-
>  2 files changed, 117 insertions(+), 1 deletion(-)
> 
> @@ -735,6 +760,75 @@ &pcie1_phy {
>  	status = "okay";
>  };
>  
> +&pcie1_port {
> +	pcie@0,0 {
> +		compatible = "pci1179,0623", "pciclass,0604";
> +		reg = <0x10000 0x0 0x0 0x0 0x0>;
> +		#address-cells = <3>;
> +		#size-cells = <2>;
> +
> +		device_type = "pci";
> +		ranges;
> +		bus-range = <0x2 0xff>;
> +
> +		vddc-supply = <&vdd_ntn_0p9>;
> +		vdd18-supply = <&vdd_ntn_1p8>;
> +		vdd09-supply = <&vdd_ntn_0p9>;
> +		vddio1-supply = <&vdd_ntn_1p8>;
> +		vddio2-supply = <&vdd_ntn_1p8>;
> +		vddio18-supply = <&vdd_ntn_1p8>;
> +
> +		i2c-parent = <&i2c0 0x77>;
> +
> +		reset-gpios = <&pm8350c_gpios 1 GPIO_ACTIVE_LOW>;
> +

I think I've responded here, but I'm not sure where the message went:
please add pinctrl entry for this pin.

-- 
With best wishes
Dmitry