Re: [PATCH v3 4/4] spi: spi-qpic-snand: set nandc_offset for ipq9574

[Gabor Juhos]

2025. 03. 10. 13:09 keltezéssel, Md Sadre Alam írta:
> The BAM block expects NAND register addresses to be computed based on
> the NAND register offset from QPIC base. This value is 0x30000 for
> ipq9574. Update the 'nandc_offset' value in the qcom_nandc_props
> appropriately.
> 
> Signed-off-by: Md Sadre Alam <quic_mdalam@xxxxxxxxxxx>
> ---
> 
> Change in [v3]
> 
> * Added nand_offset for proper address calculation
>   for newer Socs
> 
> Change in [v2]
> 
> * This patch was not part of v2
> 
> Change in [v1]
> 
> * This patch was not part of v1
> 
>  drivers/spi/spi-qpic-snand.c | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/drivers/spi/spi-qpic-snand.c b/drivers/spi/spi-qpic-snand.c
> index 8c413a6a5152..85a742e21cf9 100644
> --- a/drivers/spi/spi-qpic-snand.c
> +++ b/drivers/spi/spi-qpic-snand.c
> @@ -1604,6 +1604,7 @@ static void qcom_spi_remove(struct platform_device *pdev)
>  static const struct qcom_nandc_props ipq9574_snandc_props = {
>  	.dev_cmd_reg_start = 0x7000,
>  	.supports_bam = true,
> +	.nandc_offset = 0x30000,
>  };

Applying the first patch alone results in the following error on IPQ9574:

[    3.596403] qcom_snand 79b0000.spi: failure in submitting cmd descriptor
[    3.596490] spi-nand spi0.0: probe with driver spi-nand failed with error -110

So this change should be integrated into the first patch. Otherwise, SPI NAND
support would be broken on IPQ9574 temporarily between the first and the
current patch.

Regards,
Gabor