Hello,
thanks for your contribution and sorry for the late reply!
On Wed, Mar 19, 2025 at 8:02 PM Ferass El Hafidi
<funderscore@xxxxxxxxxxxxxxxx> wrote:
[...]
+ au2: analog-amplifier {I couldn't find any pictures online that show an analog audio output
+ compatible = "simple-audio-amplifier";
+ sound-name-prefix = "AU2";
+ VCC-supply = <&vcc_5v>;
+ enable-gpios = <&gpio GPIOH_5 GPIO_ACTIVE_HIGH>;
+ };
(typically a 3.5mm socket).
Can you confirm that this is really present?
[...]
+ sound {If there's no analog audio in/out then this section can be cleaned up
+ compatible = "amlogic,gx-sound-card";
+ model = "XIAOMI-AQUAMAN";
+ audio-aux-devs = <&au2>;
+ audio-widgets = "Line", "Lineout";
+ audio-routing = "AU2 INL", "ACODEC LOLN",
+ "AU2 INR", "ACODEC LORN",
+ "Lineout", "AU2 OUTL",
+ "Lineout", "AU2 OUTR";
as well - together with the references to acodec in the dai-links
below.
[...]
+/* Wireless SDIO Module (Amlogic W155S1 / Realtek RTL8821CS) */question to Neil: since we know that there's two board variants out
+&sd_emmc_b {
there (with different wifi chipsets) - are dt overlays down the road
enough (to enable Bluetooth / wifi - depending on the chipset or board
revision) or do we need to split the whole .dts?
Best regards,
Martin