Re: [PATCH v4 0/2] hid-asus: asus-wmi: refactor Ally suspend/resume

From: Luke D. Jones
Date: Mon Mar 24 2025 - 06:34:11 EST


On 24/03/25 21:11, Antheas Kapenekakis wrote:
On Mon, 24 Mar 2025 at 02:41, Luke D. Jones <luke@xxxxxxxxxx> wrote:

On 24/03/25 00:41, Antheas Kapenekakis wrote:
On Sun, 23 Mar 2025 at 03:34, Luke Jones <luke@xxxxxxxxxx> wrote:

This short series refactors the Ally suspend/resume functionality in the
asus-wmi driver along with adding support for ROG Ally MCU version checking.

The version checking is then used to toggle the use of older CSEE call hacks
that were initially used to combat Ally suspend/wake issues arising from the MCU
not clearing a particular flag on resume. ASUS have since corrected this
especially for Linux in newer firmware versions.

- hid-asus requests the MCU version and displays a warning if the version is
older than the one that fixes the issue.
- hid-asus awill also toggle the CSEE hack off, and mcu_powersave to on if the
version is high enough.

*Note: In review it was requested by Mario that I try strsep() for parsing
the version. I did try this and a few variations but the result was much
more code due to having to check more edge cases due to the input being
raw bytes. In the end the cleaned up while loop proved more robust.

- Changelog:
+ V2: https://lore.kernel.org/platform-driver-x86/20250226010129.32043-1-luke@xxxxxxxxxx/T/#t
- Adjust warning message to explicitly mention suspend issues

How did the testing go with this one, especially with mcu_powersave 0?

Appears to be good. Checked a few reboots with powersave off - it is
setting on as I expect every time. Did modules unload/load also. And
tested with it set off after boot plus suspend resumes.

Did you test suspends with mcu_powersave to 0 and rgb on? I had a few
issues you can reference the previous version for and I want to see if
you have them.

Even with powersave set to 1, the RGB does not fade anymore without the quirk

Yes I tested every scenario I could think of. I don't think the fade is something to worry about - seems like it happening at all previously was just due to suspend being held up for a bit longer and now that the hack is disabled for new FW, it relies fully on Linux suspend (async? Honestly it's never been fully clear how async it really is).

I'd rather the faster suspend/resume. And so far I've heard no complaints (although my userbase is smaller than bazzites).

Cheers,
Luke.

Antheas

Very much hope this is the end of that particular saga, and with
bazzites help we can hopefully get everyone on November MCU FW or later,
then finally remove the hack completely this year.

A small side note - I expect ASUS to fully reuse the X hardware, or at
least the bios/acpi/mcu-fw for that new windows handheld they've doing,
so fingers crossed that they actually do, and there will be nomore
suspend issues with current kernels plus this patch.

Cheers,
Luke.

- Use switch/case block to set min_version
- Set min_version to 0 by default and toggle hacks off
+ V3
- Remove noise (excess pr_info)
- Use kstrtoint, not kstrtolong
- Use __free(kfree) for allocated mem and drop goto + logging
- Use print_hex_dump() to show failed data after pr_err in mcu_request_version()
- Use pr_debug in set_ally_mcu_hack() and set_ally_mcu_powersave() plus
correct the message.
+ V4
- Change use_ally_mcu_hack var to enum to track init state and
prevent a race condition

Luke D. Jones (2):
hid-asus: check ROG Ally MCU version and warn
platform/x86: asus-wmi: Refactor Ally suspend/resume

drivers/hid/hid-asus.c | 111 ++++++++++++++++-
drivers/platform/x86/asus-wmi.c | 133 +++++++++++++++------
include/linux/platform_data/x86/asus-wmi.h | 19 +++
3 files changed, 222 insertions(+), 41 deletions(-)

--
2.49.0