Re: [PATCH v5 5/6] arm64: dts: cix: add initial CIX P1(SKY1) dts support
From: Marc Zyngier
Date: Wed Mar 26 2025 - 05:13:09 EST
On Wed, 26 Mar 2025 03:26:08 +0000,
Peter Chen <peter.chen@xxxxxxxxxxx> wrote:
>
> On 25-03-25 10:52:10, Marc Zyngier wrote:
> > > + timer {
> > > + compatible = "arm,armv8-timer";
> > > + interrupt-names = "sec-phys", "phys", "virt", "hyp-phys", "hyp-virt";
> > > + interrupts = <GIC_PPI 13 IRQ_TYPE_LEVEL_LOW 0>,
> > > + <GIC_PPI 14 IRQ_TYPE_LEVEL_LOW 0>,
> > > + <GIC_PPI 11 IRQ_TYPE_LEVEL_LOW 0>,
> > > + <GIC_PPI 10 IRQ_TYPE_LEVEL_LOW 0>,
> > > + <GIC_PPI 12 IRQ_TYPE_LEVEL_LOW 0>;
> > > + };
> > > +};
> >
> > I don't think there is anything wrong here, but it is also a pretty
> > useless DT. There isn't even a UART to interact with the machine and
> > find out whether it has actually booted.
> >
>
> UEFI uses the same UART, so we could see all kernel boot logs until
> switch to use kernel UART driver for printk. If you would like boot
> to the console at initramfs, just add uart node like patchset v1.
What's the point in upstreaming something that requires extra changes
just to boot it? It only outlines these patches are not useful as they
stand.
>
> > I reckon this should be part of the initial DT, as this otherwise
> > serves little purpose.
> >
>
> Without this initial support, we can't add some base drivers, like
> mailbox. The dt_binding_check will report warnings/errors [1].
Of course you can. You just add additional patches to this series,
making it something that is actually useful. So far, this series only
serves as marketing material.
> Full UART support depends on clock, clock control needs mailbox
> to talk with FW using SCMI protocol.
Then do it. You obviously have existing DT support for it already.
> There is no any support for CIX SoC, so we had to add one small step by
> step.
No, you are deliberately choosing to make this platform useless.
That's a bit sad, and a waste of everybody's time.
M.
--
Without deviation from the norm, progress is not possible.