Re: [PATCH v2] arm64: dts: imx8mp: Add device tree for Nitrogen8M Plus ENC Carrier Board

[Rob Herring (Arm)]

On Thu, 27 Mar 2025 12:39:02 +0000, Martyn Welch wrote:
> Add support for Boundary Devices/Ezurio Nitrogen8M Plus ENC Carrier
> Board and it's SOM. Supported interfaces:
> 
>  - Serial Console
>  - EQoS Ethernet
>  - USB
>  - eMMC
>  - HDMI
> 
> Signed-off-by: Martyn Welch <martyn.welch@xxxxxxxxxxxxx>
> ---
> 
> Changes in v2:
>  - Add missing entries to binding documents.
> 
>  .../devicetree/bindings/arm/fsl.yaml          |   6 +
>  arch/arm64/boot/dts/freescale/Makefile        |   1 +
>  .../imx8mp-nitrogen-enc-carrier-board.dts     | 478 ++++++++++++++++++
>  .../dts/freescale/imx8mp-nitrogen-som.dtsi    | 415 +++++++++++++++
>  4 files changed, 900 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dts
>  create mode 100644 arch/arm64/boot/dts/freescale/imx8mp-nitrogen-som.dtsi
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


This patch series was applied (using b4) to base:
 Base: attempting to guess base-commit...
 Base: failed to guess base

If this is not the correct base, please add 'base-commit' tag
(or use b4 which does this automatically)

New warnings running 'make CHECK_DTBS=y for arch/arm64/boot/dts/freescale/' for 20250327123907.542132-1-martyn.welch@xxxxxxxxxxxxx:

arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: pinctrl@30330000: 'usdhc1grp-100mhz', 'usdhc1grp-200mhz', 'usdhc1grp-gpio' do not match any of the regexes: 'grp$', 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/pinctrl/fsl,imx8m-pinctrl.yaml#
arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: pinctrl@30330000: usdhc1grp-gpio: {'fsl,pins': [[184, 792, 0, 5, 0, 452]], 'phandle': 71} is not of type 'array'
	from schema $id: http://devicetree.org/schemas/gpio/gpio-consumer.yaml#
arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: pmic@25: regulators:BUCK2: Unevaluated properties are not allowed ('regulator-limit-microvolt' was unexpected)
	from schema $id: http://devicetree.org/schemas/regulator/nxp,pca9450-regulator.yaml#
arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: i2cmux9546@70: Unevaluated properties are not allowed ('i2c2@0', 'i2c2@1', 'i2c2@2', 'i2c2@3' were unexpected)
	from schema $id: http://devicetree.org/schemas/i2c/i2c-mux-pca954x.yaml#
arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: usb-phy@381f0040: Unevaluated properties are not allowed ('fsl,phy-tx-preemp-amp-tune' was unexpected)
	from schema $id: http://devicetree.org/schemas/phy/fsl,imx8mq-usb-phy.yaml#
arch/arm64/boot/dts/freescale/imx8mp-nitrogen-enc-carrier-board.dtb: usb-phy@382f0040: Unevaluated properties are not allowed ('fsl,phy-tx-preemp-amp-tune' was unexpected)
	from schema $id: http://devicetree.org/schemas/phy/fsl,imx8mq-usb-phy.yaml#