Re: [PATCH v3] i2c: npcm: Add clock toggle recovery

[Mukesh Kumar Savaliya]

On 3/28/2025 1:08 AM, mohammed.0.elbadry@xxxxxxxxx wrote:
> From: Tali Perry <tali.perry1@xxxxxxxxx>
>
> During init of the bus, the module checks that the bus is idle.
> If one of the lines are stuck try to recover them first before failing.
> Sometimes SDA and SCL are low if improper reset occurs (e.g., reboot).
>
> Signed-off-by: Tali Perry <tali.perry1@xxxxxxxxx>
> Signed-off-by: Mohammed Elbadry <mohammed.0.elbadry@xxxxxxxxx>
> ---
>   drivers/i2c/busses/i2c-npcm7xx.c | 12 ++++++++----
>   1 file changed, 8 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-npcm7xx.c b/drivers/i2c/busses/i2c-npcm7xx.c
> index 2fe68615942e..f05cae20cb27 100644
> --- a/drivers/i2c/busses/i2c-npcm7xx.c
> +++ b/drivers/i2c/busses/i2c-npcm7xx.c
> @@ -1967,10 +1967,14 @@ static int npcm_i2c_init_module(struct npcm_i2c *bus, enum i2c_mode mode,
>   
>   	/* Check HW is OK: SDA and SCL should be high at this point. */
>   	if ((npcm_i2c_get_SDA(&bus->adap) == 0) || (npcm_i2c_get_SCL(&bus->adap) == 0)) {
> -		dev_err(bus->dev, "I2C%d init fail: lines are low\n", bus->num);
> -		dev_err(bus->dev, "SDA=%d SCL=%d\n", npcm_i2c_get_SDA(&bus->adap),
> -			npcm_i2c_get_SCL(&bus->adap));
> -		return -ENXIO;
> +		dev_warn(bus->dev, " I2C%d SDA=%d SCL=%d, attempt recover\n", bus->num,
> +				 npcm_i2c_get_SDA(&bus->adap), npcm_i2c_get_SCL(&bus->adap));
> +		if (npcm_i2c_recovery_tgclk(&bus->adap)) {
You are here post trying recovery. In the log below you may want to add, 
"Post recovery" ? instead of "init fail" ? Just a suggestion.
> +			dev_err(bus->dev, "I2C%d init fail: lines are low, SDA=%d SCL=%d\n",
> +				bus->num, npcm_i2c_get_SDA(&bus->adap),
Thanks for making previous change. Now "lines are low" not relevant as 
you just need to print status 1 or 0.
> +				npcm_i2c_get_SCL(&bus->adap));
> +			return -ENXIO;
> +		}
>   	}
>   
>   	npcm_i2c_int_enable(bus, true);