[PATCH 5/5] scsi: hisi_sas: Wait until eh is recovered

[Yihang Li]

SATA devices are lost when FLR is performed while the controller and disks
are in suspended state.

This is because the libata layer is called to initialize the SATA device
during controller resuming. If FLR is executed at this time, the IDENTIFY
command fails. As a result, the revalidate fails, and the SATA device is
disabled by the libata layer.

So, wait until eh is recovered.

Signed-off-by: Yihang Li <liyihang9@xxxxxxxxxx>
---
 drivers/scsi/hisi_sas/hisi_sas_v3_hw.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
index c3cbeb556440..97ff48e7fe5d 100644
--- a/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
+++ b/drivers/scsi/hisi_sas/hisi_sas_v3_hw.c
@@ -5130,9 +5130,11 @@ static void hisi_sas_reset_prepare_v3_hw(struct pci_dev *pdev)
 {
 	struct sas_ha_struct *sha = pci_get_drvdata(pdev);
 	struct hisi_hba *hisi_hba = sha->lldd_ha;
+	struct Scsi_Host *shost = hisi_hba->shost;
 	struct device *dev = hisi_hba->dev;
 	int rc;
 
+	wait_event(shost->host_wait, !scsi_host_in_recovery(shost));
 	dev_info(dev, "FLR prepare\n");
 	down(&hisi_hba->sem);
 	set_bit(HISI_SAS_RESETTING_BIT, &hisi_hba->flags);
-- 
2.33.0