Re: [PATCH 0/5] Add support for Battery Status & Battery Caps AMS in TCPM

From: Amit Sunil Dhamne
Date: Wed Apr 02 2025 - 23:41:20 EST



On 3/21/25 12:51 AM, Krzysztof Kozlowski wrote:
On 20/03/2025 22:11, Amit Sunil Dhamne wrote:
On 3/16/25 9:52 AM, Krzysztof Kozlowski wrote:
On 15/03/2025 01:49, Amit Sunil Dhamne wrote:
Hi Krzysztof,

Thanks for the review!

On 3/13/25 1:50 AM, Krzysztof Kozlowski wrote:
On Wed, Mar 12, 2025 at 04:42:00PM -0700, Amit Sunil Dhamne wrote:
Support for Battery Status & Battery Caps messages in response to
Get_Battery_Status & Get_Battery_Cap request is required by USB PD devices
powered by battery, as per "USB PD R3.1 V1.8 Spec", "6.13 Message
Applicability" section. This patchset adds support for these AMSes
to achieve greater compliance with the spec.
Which board uses it? I would be happy to see that connection between
batteries and USB connector on the schematics of some real device. How
does it look like?
Any board that uses a USB Type-C connector that supplies power into or
If you keep responding like this, you will got nowhere, so let me
re-iterate:

Which upstream DTS (or upstream supported hardware) is going to use this
binding, so I can see how you are going to implement it there in the
entire system?
This is for maxim,max33359 Type-C controller.
Stop deflecting the questions. max33359 is not a board. I already asked
two times.

Apparently admitting "no upstream users" is impossible, so let's state
the obvious:

There are no upstream users of this.

max33359 controller has an upstream user i.e., gs101-oriole (Pixel 6) board. Totally agree that at the moment there are no upstream devices/drivers for the Fuel Gauge (that my patchset has a dependency on) in gs101-oriole board. gs101-oriole uses max77759 fuel gauge device. I see that there's an effort for upstreaming it (https://lore.kernel.org/all/20250102-b4-gs101_max77759_fg-v2-0-87959abeb7ff@xxxxxxxxxxxx/). I will mark my patches as dependent on it + demonstrate the relationship of the devices in the gs101-oriole board. Hope that's okay?


Thanks,

Amit

This would property would have been present for the connector present in
the typec device for gs101-oriole board (that uses the max33359
controller).

But it is not.


However, I will be exploring existing bindings to describe the
relationship for now.

out of a battery while operating in sink or source mode respectively.
The VBUS is connected to the (battery + buck boost IC's CHGin/Vin) or a
companion IFPMIC connected to a battery.  In our board we have USB
Connector <-> IFPMIC <-> Battery.
Which board is that?
gs101-oriole board.

Then why this is not used? The board was released some years ago, so I
do not see a problem in using it.

Best regards,
Krzysztof