[PATCH 1/6] gpio: zynq: enable building the modules with COMPILE_TEST=y

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>

Extend the build coverage by allowing to build the modules with
COMPILE_TEST enabled.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
---
 drivers/gpio/Kconfig | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index f2c39bbff83a..f76d08880fe5 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -830,14 +830,14 @@ config GPIO_ZEVIO
 
 config GPIO_ZYNQ
 	tristate "Xilinx Zynq GPIO support"
-	depends on ARCH_ZYNQ || ARCH_ZYNQMP
+	depends on ARCH_ZYNQ || ARCH_ZYNQMP || COMPILE_TEST
 	select GPIOLIB_IRQCHIP
 	help
 	  Say yes here to support Xilinx Zynq GPIO controller.
 
 config GPIO_ZYNQMP_MODEPIN
 	tristate "ZynqMP ps-mode pin GPIO configuration driver"
-	depends on ZYNQMP_FIRMWARE
+	depends on ZYNQMP_FIRMWARE || COMPILE_TEST
 	default ZYNQMP_FIRMWARE
 	help
 	  Say yes here to support the ZynqMP ps-mode pin GPIO configuration

-- 
2.45.2