Re: [PATCH v6 07/12] gpio: regmap: Allow to allocate regmap-irq device

[Andy Shevchenko]

On Wed, Apr 09, 2025 at 04:55:54PM +0200, Mathieu Dubois-Briand wrote:
> GPIO controller often have support for IRQ: allow to easily allocate
> both gpio-regmap and regmap-irq in one operation.

>  
> -		memcpy(d->prev_status_buf, d->status_buf, array_size(d->prev_status_buf));
> +		memcpy(d->prev_status_buf, d->status_buf,
> +		       array_size(d->chip->num_regs, sizeof(d->prev_status_buf[0])));

...

> +#ifdef CONFIG_REGMAP_IRQ
> +	if (config->regmap_irq_chip) {
> +		struct regmap_irq_chip_data *irq_chip_data;
> +
> +		ret = devm_regmap_add_irq_chip_fwnode(config->parent, dev_fwnode(config->parent),
> +						      config->regmap, config->regmap_irq_irqno,
> +						      config->regmap_irq_flags, 0,
> +						      config->regmap_irq_chip, &irq_chip_data);
> +		if (ret)
> +			goto err_free_gpio;
> +
> +		irq_domain = regmap_irq_get_domain(irq_chip_data);
> +	} else
> +#endif
> +	irq_domain = config->irq_domain;

> +

This is blank line is not needed, but I not mind either way.

> +	if (irq_domain) {
> +		ret = gpiochip_irqchip_add_domain(chip, irq_domain);
>  		if (ret)
>  			goto err_remove_gpiochip;
>  	}

...

> + * @regmap_irq_chip:	(Optional) Pointer on an regmap_irq_chip structure. If
> + *			set, a regmap-irq device will be created and the IRQ
> + *			domain will be set accordingly.

> + * @regmap_irq_chip_data: (Optional) Pointer on an regmap_irq_chip_data
> + *                      structure pointer. If set, it will be populated with a
> + *                      pointer on allocated regmap_irq data.

Leftover?

> + * @regmap_irq_irqno	(Optional) The IRQ the device uses to signal interrupts.
> + * @regmap_irq_flags	(Optional) The IRQF_ flags to use for the interrupt.

...

> +#ifdef CONFIG_REGMAP_IRQ
> +	struct regmap_irq_chip *regmap_irq_chip;
> +	int regmap_irq_irqno;

Perhaps call it line?

	int regmap_irq_line;

> +	unsigned long regmap_irq_flags;
> +#endif

-- 
With Best Regards,
Andy Shevchenko