Re: [PATCH] cxl/core/regs.c: Skip Memory Space Enable check for RCD and RCH Ports
From: Dave Jiang
Date: Thu Apr 10 2025 - 11:14:54 EST
On 4/7/25 12:27 PM, Smita Koralahalli wrote:
> According to CXL r3.2 section 8.2.1.2, the PCI_COMMAND register fields,
> including Memory Space Enable bit, have no effect on the behavior of an
> RCD Upstream Port. Retaining this check may incorrectly cause
> cxl_pci_probe() to fail on a valid RCD upstream Port.
>
> While the specification is explicit only for RCD Upstream Ports, this
> check is solely for accessing the RCRB, which is always mapped through
> memory space. Therefore, its safe to remove the check entirely. In
> practice, firmware reliably enables the Memory Space Enable bit for
> RCH Downstream Ports and no failures have been observed.
>
> Removing the check simplifies the code and avoids unnecessary
> special-casing, while relying on BIOS/firmware to configure devices
> correctly. Moreover, any failures due to inaccessible RCRB regions
> will still be caught either in __rcrb_to_component() or while
> parsing the component register block.
>
> The following failure was observed in dmesg when the check was present:
> cxl_pci 0000:7f:00.0: No component registers (-6)
>
> Fixes: d5b1a27143cb ("cxl/acpi: Extract component registers of restricted hosts from RCRB")
> Signed-off-by: Smita Koralahalli <Smita.KoralahalliChannabasappa@xxxxxxx>
Reviewed-by: Dave Jiang <dave.jiang@xxxxxxxxx>
> ---
> drivers/cxl/core/regs.c | 4 ----
> 1 file changed, 4 deletions(-)
>
> diff --git a/drivers/cxl/core/regs.c b/drivers/cxl/core/regs.c
> index 117c2e94c761..5ca7b0eed568 100644
> --- a/drivers/cxl/core/regs.c
> +++ b/drivers/cxl/core/regs.c
> @@ -581,7 +581,6 @@ resource_size_t __rcrb_to_component(struct device *dev, struct cxl_rcrb_info *ri
> resource_size_t rcrb = ri->base;
> void __iomem *addr;
> u32 bar0, bar1;
> - u16 cmd;
> u32 id;
>
> if (which == CXL_RCRB_UPSTREAM)
> @@ -603,7 +602,6 @@ resource_size_t __rcrb_to_component(struct device *dev, struct cxl_rcrb_info *ri
> }
>
> id = readl(addr + PCI_VENDOR_ID);
> - cmd = readw(addr + PCI_COMMAND);
> bar0 = readl(addr + PCI_BASE_ADDRESS_0);
> bar1 = readl(addr + PCI_BASE_ADDRESS_1);
> iounmap(addr);
> @@ -618,8 +616,6 @@ resource_size_t __rcrb_to_component(struct device *dev, struct cxl_rcrb_info *ri
> dev_err(dev, "Failed to access Downstream Port RCRB\n");
> return CXL_RESOURCE_NONE;
> }
> - if (!(cmd & PCI_COMMAND_MEMORY))
> - return CXL_RESOURCE_NONE;
> /* The RCRB is a Memory Window, and the MEM_TYPE_1M bit is obsolete */
> if (bar0 & (PCI_BASE_ADDRESS_MEM_TYPE_1M | PCI_BASE_ADDRESS_SPACE_IO))
> return CXL_RESOURCE_NONE;