Re: [PATCH v2 3/5] iio: adc: ad7606: add offset and phase calibration support

[Andy Shevchenko]

On Fri, May 02, 2025 at 03:27:00PM +0200, Angelo Dureghello wrote:
> From: Angelo Dureghello <adureghello@xxxxxxxxxxxx>
> 
> Add support for offset and phase calibration, only for
> devices that support software mode, that are:
> 
> ad7606b
> ad7606c-16
> ad7606c-18

...

> +static int ad7606_get_calib_offset(struct ad7606_state *st, int ch, int *val)
> +{
> +	int ret;
> +
> +	ret = st->bops->reg_read(st, AD7606_CALIB_OFFSET(ch));
> +	if (ret < 0)
> +		return ret;
> +
> +	*val = st->chip_info->calib_offset_avail[0] +
> +		ret * st->chip_info->calib_offset_avail[1];

Something wrong with the indentation.

> +	return 0;
> +}

...

> +static int ad7606_set_calib_offset(struct ad7606_state *st, int ch, int val)
> +{
> +	int start_val, step_val, stop_val;

All need to be signed?

> +	start_val = st->chip_info->calib_offset_avail[0];
> +	step_val = st->chip_info->calib_offset_avail[1];
> +	stop_val = st->chip_info->calib_offset_avail[2];
> +
> +	if (val < start_val || val > stop_val)
> +		return -EINVAL;
> +
> +	val -= start_val;
> +	val /= step_val;
> +
> +	return st->bops->reg_write(st, AD7606_CALIB_OFFSET(ch), val);
> +}

...

> +static int ad7606_set_calib_phase(struct ad7606_state *st, int ch, int val,
> +				  int val2)
> +{
> +	int wreg, start_ns, step_ns, stop_ns;

Ditto.

> +	if (val != 0)
> +		return -EINVAL;
> +
> +	start_ns = st->chip_info->calib_phase_avail[0][1];
> +	step_ns = st->chip_info->calib_phase_avail[1][1];
> +	stop_ns = st->chip_info->calib_phase_avail[2][1];
> +
> +	/*
> +	 * ad7606b: phase dielay from 0 to 318.75 μs in steps of 1.25 μs.
> +	 * ad7606c-16/18: phase delay from 0 µs to 255 µs in steps of 1 µs.
> +	 */
> +	if (val2 < start_ns || val2 > stop_ns)
> +			return -EINVAL;

Wrong indentation. Please fix in all places where it happens.

> +	wreg = val2 / step_ns;
> +
> +	return st->bops->reg_write(st, AD7606_CALIB_PHASE(ch), wreg);
> +}

-- 
With Best Regards,
Andy Shevchenko