[PATCH v2 2/4] arm64: dts: ti: k3-am62x: Add required voltage supplies for IMX219

From: Rishikesh Donadkar
Date: Fri May 02 2025 - 12:27:57 EST


The device tree overlay for the IMX219 sensor requires three voltage
supplies to be defined: VANA (analog), VDIG (digital core), and VDDL
(digital I/O) [1].

Add the corresponding voltage supply definitions in the overlay so
that the same topography as dt-bindings is present in the DT overlay.

Link: https://datasheets.raspberrypi.com/camera/camera-module-2-schematics.pdf [1]
Reviewed-by: Devarsh Thakkar <devarsht@xxxxxx>
Signed-off-by: Rishikesh Donadkar <r-donadkar@xxxxxx>
---
.../boot/dts/ti/k3-am62x-sk-csi2-imx219.dtso | 31 +++++++++++++++++++
1 file changed, 31 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62x-sk-csi2-imx219.dtso b/arch/arm64/boot/dts/ti/k3-am62x-sk-csi2-imx219.dtso
index dd090813a32d6..149c59c071823 100644
--- a/arch/arm64/boot/dts/ti/k3-am62x-sk-csi2-imx219.dtso
+++ b/arch/arm64/boot/dts/ti/k3-am62x-sk-csi2-imx219.dtso
@@ -15,6 +15,33 @@ clk_imx219_fixed: imx219-xclk {
#clock-cells = <0>;
clock-frequency = <24000000>;
};
+
+ reg_2p8v: regulator-2p8v {
+ compatible = "regulator-fixed";
+ regulator-name = "2P8V";
+ regulator-min-microvolt = <2800000>;
+ regulator-max-microvolt = <2800000>;
+ vin-supply = <&vcc_3v3_sys>;
+ regulator-always-on;
+ };
+
+ reg_1p8v: regulator-1p8v {
+ compatible = "regulator-fixed";
+ regulator-name = "1P8V";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ vin-supply = <&vcc_3v3_sys>;
+ regulator-always-on;
+ };
+
+ reg_1p2v: regulator-1p2v {
+ compatible = "regulator-fixed";
+ regulator-name = "1P2V";
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ vin-supply = <&vcc_3v3_sys>;
+ regulator-always-on;
+ };
};

&main_i2c2 {
@@ -40,6 +67,10 @@ ov5640: camera@10 {

clocks = <&clk_imx219_fixed>;

+ VANA-supply = <&reg_2p8v>;
+ VDIG-supply = <&reg_1p8v>;
+ VDDL-supply = <&reg_1p2v>;
+
reset-gpios = <&exp1 13 GPIO_ACTIVE_HIGH>;

port {
--
2.34.1