Re: [RFC PATCH 07/11] arm64: dts: imx8mp: fix VPU_BUS clock setting

[Marco Felsch]

On 25-05-02, Adam Ford wrote:
> On Fri, May 2, 2025 at 10:10 AM Marco Felsch <m.felsch@xxxxxxxxxxxxxx> wrote:
> >
> > The VPU_PLL clock must be set before the VPU_BUS clock which is derived
> > from the VPU_PLL clock else the VPU_BUS clock is 300MHz and not 600MHz.
> >
> > Signed-off-by: Marco Felsch <m.felsch@xxxxxxxxxxxxxx>
> > ---
> >  arch/arm64/boot/dts/freescale/imx8mp.dtsi | 4 ++--
> >  1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/freescale/imx8mp.dtsi b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > index 97b09b647ec7..7f4bdefb3480 100644
> > --- a/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > +++ b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
> > @@ -2289,8 +2289,8 @@ vpumix_blk_ctrl: blk-ctrl@38330000 {
> >                                  <&clk IMX8MP_CLK_VPU_G2_ROOT>,
> >                                  <&clk IMX8MP_CLK_VPU_VC8KE_ROOT>;
> >                         clock-names = "g1", "g2", "vc8000e";
> > -                       assigned-clocks = <&clk IMX8MP_CLK_VPU_BUS>, <&clk IMX8MP_VPU_PLL>;
> > -                       assigned-clock-parents = <&clk IMX8MP_VPU_PLL_OUT>;
> > +                       assigned-clocks = <&clk IMX8MP_VPU_PLL>, <&clk IMX8MP_CLK_VPU_BUS>;
> > +                       assigned-clock-parents = <0>, <&clk IMX8MP_VPU_PLL_OUT>;
> >                         assigned-clock-rates = <600000000>, <600000000>;
> 
> I think there was a move to make the default be overdrive [1]  and [2]
> and use a 'nominal' device tree for those who are not in overdrive
> mode.  According to the TRM, the VPU_BUS_CLK_ROOT, the nominal is
> 600MHz and the overdrive is 800MHz.  Based on that, I wonder if the
> values here should be 800MHz and if we should add the nominal values
> of 600MHz to the imx8m-nominal.dtsi file.

You're right, Ahamd and Lucas did change this. I will adapt it later on.

Regards,
  Marco