Re: [PATCH v2 3/6] arm64: dts: qcom: r0q: add touchscreen support

[Ghatto]

On Tue, Oct 14, 2025 at 7:01 AM Konrad Dybcio
<konrad.dybcio@xxxxxxxxxxxxxxxx> wrote:
>
> On 10/14/25 6:41 AM, Eric Gonçalves wrote:
> > Enable the ST-Microelectronics FTS2BA61Y touchscreen. This patch
> > depends on "Input: add support for the STM FTS2BA61Y touchscreen".
>
> The second sentence doesn't really make sense to be included in
> the git log
I'll keep it to the cover letter then
>
> > The device has an issue where SPI 8 (the bus which the touchscreen is
> > connected to) is not working properly right now, so
> > spi-gpio is used instead.
>
> Some Samsung devices used to use spi/i2c-gpio intentionally, also
> on downstream. I'm assuming this isn't the case for r0q.
It isn't, the device uses fts2ba61y on the spi8 bus - I hosted the
DT at https://github.com/ghatt-o/ss_experiments/blob/main/r0q.dts if you
want to take a look.
>
> Did you enable gpi_dma1, qupv3_id_1 before spi8, when testing
The driver probes, but it fails to recognize the touchscreen device
and ends up erroring, spi-gpio solves this and I did try enabling those.
It also works on the S22+ with spi-gpio, so I decided to do the same on r0q.
> that? I don't see any obvious errors in the dt that would cause
> problems
>
> Konrad