Re: [PATCH 4/6] spi: axi-spi-engine: support SPI_MULTI_BUS_MODE_STRIPE

[David Lechner]

On 10/15/25 5:30 AM, Nuno Sá wrote:
> On Tue, 2025-10-14 at 17:02 -0500, David Lechner wrote:
>> Add support for SPI_MULTI_BUS_MODE_STRIPE to the AXI SPI engine driver.
>>

...

>> +
>> +		if (xfer->rx_buf || xfer->offload_flags &
>> SPI_OFFLOAD_XFER_RX_STREAM ||
>> +		    xfer->tx_buf || xfer->offload_flags &
>> SPI_OFFLOAD_XFER_TX_STREAM) {
> 
> I'm a bit confused by this condition. It looks like setting priv->multi_bus_mode
> (and the other fields) only matters for msg->offload but the above will be true
> for regular rx/tx messages, right? Or am i missing something?

You are correct.

> 
> If so, I wonder why doing this for all transfers if we only care about
> multi_bus_mode for offload messages. I guess you want to validate
> xfer->multi_bus_mode?

Yes, this is important to validate it since we don't support all possible modes.
The mode still applies to the individual xfer even when not using SPI offloading.

> I would then just take the switch() out of the condition
> (I mean trying to setup a no data xfer with an invalid bus_mode should also be
> seen as invalid IMO) and then use the offload conditions (or maybe simply msg-
>> offload?) for the multi_bus_mode handling. To me, it makes the intent more
> clear.

It the validation only matters for xfers that send or receive data. I guess
it doesn't hurt to check the mode in non-data xfers (e.g. ones with just a delay)
but since we needed the condition anyway for the accumulator, it made sense to
me to put it inside the conditional.

I might have put an additional if (msg->offload) around the accumulator part
since it only matters when using SPI offloading, but the indent was already
getting quite deep.