[PATCH net-next v2 2/3] net: stmmac: loongson: Use generic PCI suspend/resume routines

[Yao Zi]

Convert glue driver for Loongson DWMAC controller to use the generic
platform suspend/resume routines for PCI controllers, instead of
implementing its own one.

Signed-off-by: Yao Zi <ziyao@xxxxxxxxxxx>
---
 drivers/net/ethernet/stmicro/stmmac/Kconfig   |  1 +
 .../ethernet/stmicro/stmmac/dwmac-loongson.c  | 36 ++-----------------
 2 files changed, 4 insertions(+), 33 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/Kconfig b/drivers/net/ethernet/stmicro/stmmac/Kconfig
index 598bc56edd8d..4b6911c62e6f 100644
--- a/drivers/net/ethernet/stmicro/stmmac/Kconfig
+++ b/drivers/net/ethernet/stmicro/stmmac/Kconfig
@@ -373,6 +373,7 @@ config DWMAC_LOONGSON
 	default MACH_LOONGSON64
 	depends on (MACH_LOONGSON64 || COMPILE_TEST) && STMMAC_ETH && PCI
 	depends on COMMON_CLK
+	depends on STMMAC_LIBPCI
 	help
 	  This selects the LOONGSON PCI bus support for the stmmac driver,
 	  Support for ethernet controller on Loongson-2K1000 SoC and LS7A1000 bridge.
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
index 2a3ac0136cdb..584dc4ff8320 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
@@ -8,6 +8,7 @@
 #include <linux/device.h>
 #include <linux/of_irq.h>
 #include "stmmac.h"
+#include "stmmac_libpci.h"
 #include "dwmac_dma.h"
 #include "dwmac1000.h"
 
@@ -525,37 +526,6 @@ static int loongson_dwmac_fix_reset(struct stmmac_priv *priv, void __iomem *ioad
 				  10000, 2000000);
 }
 
-static int loongson_dwmac_suspend(struct device *dev, void *bsp_priv)
-{
-	struct pci_dev *pdev = to_pci_dev(dev);
-	int ret;
-
-	ret = pci_save_state(pdev);
-	if (ret)
-		return ret;
-
-	pci_disable_device(pdev);
-	pci_wake_from_d3(pdev, true);
-	return 0;
-}
-
-static int loongson_dwmac_resume(struct device *dev, void *bsp_priv)
-{
-	struct pci_dev *pdev = to_pci_dev(dev);
-	int ret;
-
-	pci_restore_state(pdev);
-	pci_set_power_state(pdev, PCI_D0);
-
-	ret = pci_enable_device(pdev);
-	if (ret)
-		return ret;
-
-	pci_set_master(pdev);
-
-	return 0;
-}
-
 static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 {
 	struct plat_stmmacenet_data *plat;
@@ -600,8 +570,8 @@ static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id
 	plat->bsp_priv = ld;
 	plat->setup = loongson_dwmac_setup;
 	plat->fix_soc_reset = loongson_dwmac_fix_reset;
-	plat->suspend = loongson_dwmac_suspend;
-	plat->resume = loongson_dwmac_resume;
+	plat->suspend = stmmac_pci_plat_suspend;
+	plat->resume = stmmac_pci_plat_resume;
 	ld->dev = &pdev->dev;
 	ld->loongson_id = readl(res.addr + GMAC_VERSION) & 0xff;
 
-- 
2.51.2