[PATCH 1/2] vdpa/mlx5: update mlx_features with driver state check

[Cindy Lu]

Add logic in mlx5_vdpa_set_attr() to ensure the VIRTIO_NET_F_MAC
feature bit is properly set only when the device is not yet in
the DRIVER_OK (running) state.

This makes the MAC address visible in the output of:

 vdpa dev config show -jp

when the device is created without an initial MAC address.

Signed-off-by: Cindy Lu <lulu@xxxxxxxxxx>
---
 drivers/vdpa/mlx5/net/mlx5_vnet.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/vdpa/mlx5/net/mlx5_vnet.c b/drivers/vdpa/mlx5/net/mlx5_vnet.c
index 82034efb74fc..e38aa3a335fc 100644
--- a/drivers/vdpa/mlx5/net/mlx5_vnet.c
+++ b/drivers/vdpa/mlx5/net/mlx5_vnet.c
@@ -4057,6 +4057,12 @@ static int mlx5_vdpa_set_attr(struct vdpa_mgmt_dev *v_mdev, struct vdpa_device *
 	ndev = to_mlx5_vdpa_ndev(mvdev);
 	mdev = mvdev->mdev;
 	config = &ndev->config;
+	if (!(ndev->mvdev.status & VIRTIO_CONFIG_S_DRIVER_OK)) {
+		ndev->mvdev.mlx_features |= BIT_ULL(VIRTIO_NET_F_MAC);
+	} else {
+		mlx5_vdpa_warn(mvdev, "device running, skip updating MAC\n");
+		return err;
+	}
 
 	down_write(&ndev->reslock);
 	if (add_config->mask & (1 << VDPA_ATTR_DEV_NET_CFG_MACADDR)) {
-- 
2.45.0