Re: [PATCH net-next v2 2/3] net: stmmac: Add glue driver for Motorcomm YT6801 ethernet controller

[Yao Zi]

On Tue, Nov 11, 2025 at 11:07:24AM +0000, Russell King (Oracle) wrote:
> On Tue, Nov 11, 2025 at 10:52:51AM +0000, Yao Zi wrote:
> > +	plat->bus_id		= pci_dev_id(pdev);
> > +	plat->phy_addr		= -1;
> > +	plat->phy_interface	= PHY_INTERFACE_MODE_GMII;
> > +	plat->clk_csr		= STMMAC_CSR_20_35M;
> > +	plat->tx_coe		= 1;
> > +	plat->rx_coe		= 1;
> > +	plat->maxmtu		= JUMBO_LEN;
> > +	plat->rx_queues_to_use	= 1;
> > +	plat->tx_queues_to_use	= 1;
> > +	plat->clk_ref_rate	= 125000000;
> > +	plat->core_type		= DWMAC_CORE_GMAC4;
> > +	plat->suspend		= stmmac_pci_plat_suspend;
> > +	plat->resume		= motorcomm_resume;
> > +	plat->flags		= STMMAC_FLAG_TSO_EN;
> 
> Can you also set STMMAC_FLAG_EN_TX_LPI_CLK_PHY_CAP here, so if EEE
> is used, we can shut down the transmit clock to the PHY if the PHY
> supports that? I would like all new glue drivers to set this where
> possible please.

Yes, the flag could be set and I'll do it in v3.

Regards,
Yao Zi

> Thanks.
> 
> -- 
> RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
> FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!