Re: [PATCH v23 1/4] dt-bindings: i2c: Split AST2600 binding into a new YAML

[Rob Herring (Arm)]

On Mon, 17 Nov 2025 10:50:37 +0800, Ryan Chen wrote:
> The AST2600 I2C controller introduces a completely new register
> map and Separate control/target register sets, unlike the mixed
> layout used in AST2400/AST2500.
> 
> In addition, at new AST2600 configuration registers and transfer
> modes require new DT properties, which are incompatible with
> existing bindings. Therefore, this creates a dedicated binding
> file for AST2600 to properly describe these new hardware
> capabilities.
> 
> A subsequent change will modify this new binding to properly
> describe the AST2600 hardware.
> 
> The example section updated to reflect the actual AST2600 SoC
> register layout and interrupt configuration.
> Reference: aspeed-g6.dtsi (lines 885-897)
> 
> -I2C bus and buffer register offsets
>  - AST2600 I2C controller register base starts from 0x80, and the
>    buffer region is located at 0xc00, as defined in AST2600 SOC
>    register map.
> 
> -Interrupt configuration
>  - AST2600 I2C controller are connected to ARM GIC interrupt
>    controller rather than the legacy internal interrupt controller.
> 
> Signed-off-by: Ryan Chen <ryan_chen@xxxxxxxxxxxxxx>
> ---
>  .../bindings/i2c/aspeed,ast2600-i2c.yaml      | 66 +++++++++++++++++++
>  .../devicetree/bindings/i2c/aspeed,i2c.yaml   |  3 +-
>  2 files changed, 67 insertions(+), 2 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/i2c/aspeed,ast2600-i2c.yaml
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:
./Documentation/devicetree/bindings/i2c/aspeed,ast2600-i2c.yaml:25:1: [warning] too many blank lines (2 > 1) (empty-lines)

dtschema/dtc warnings/errors:

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20251117025040.3622984-2-ryan_chen@xxxxxxxxxxxxxx

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.