Re: [PATCH 1/2] dt-bindings: mux: gpio-mux: add support for ADG1712

From: Rob Herring (Arm)

Date: Fri Nov 21 2025 - 08:44:59 EST



On Fri, 21 Nov 2025 11:57:31 +0000, Antoniu Miclaus wrote:
> Add support for the Analog Devices ADG1712 quad SPST switch to the
> existing GPIO multiplexer bindings. The ADG1712 contains four
> independent single-pole/single-throw (SPST) switches, each controlled
> by a dedicated GPIO pin.
>
> Unlike traditional multiplexers that use GPIOs as binary-encoded
> selectors, the ADG1712 treats each GPIO as a direct switch controller.
> The mux state represents the combination of all four switches, with
> values from 0-15 corresponding to different switch combinations.
>
> For example, state 5 (binary 0101) represents:
> - SW1: ON (GPIO0 = 1)
> - SW2: OFF (GPIO1 = 0)
> - SW3: ON (GPIO2 = 1)
> - SW4: OFF (GPIO3 = 0)
>
> Signed-off-by: Antoniu Miclaus <antoniu.miclaus@xxxxxxxxxx>
> ---
> .../devicetree/bindings/mux/gpio-mux.yaml | 24 ++++++++++++++++++-
> 1 file changed, 23 insertions(+), 1 deletion(-)
>

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mux/gpio-mux.example.dtb: switch-controller (adi,adg1712): $nodename:0: 'switch-controller' does not match '^mux-controller(@.*|-([0-9]|[1-9][0-9]+))?$'
from schema $id: http://devicetree.org/schemas/mux/mux-controller.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20251121115750.20119-2-antoniu.miclaus@xxxxxxxxxx

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.