Re: [PATCH v2 0/4] s32g: Use a syscon for GPR

[Dan Carpenter]

On Tue, Dec 16, 2025 at 09:42:06AM -0500, Frank Li wrote:
> > >
> > > Why not implement standard phy interface,
> > > phy_set_mode_ext(PHY_MODE_ETHERNET, RGMII);
> > >
> > > For example:  drivers/pci/controller/dwc/pci-imx6.c
> > >
> > > In legency platform, it use syscon to set some registers. It becomes mess
> > > when more platform added.  And it becomes hard to convert because avoid
> > > break compatibltiy now.
> > >
> > > It doesn't become worse since new platforms switched to use standard
> > > inteface, (phy, reset ...).
> > >
> >
> > This happens below that layer, this is just saying where the registers
> > are found.  The GMAC_0_CTRL_STS is just one register in the GPR region,
> > most of the others are unrelated to PHY.
> 
> The other register should work as other function's providor with mfd.
> 

Syscons are a really standard way to do register accesses.  The
pci-imx6.c driver you mentioned earlier does it that way...  The only
thing which my code does differently is I put the offset into the
phandle, but that's not so unusual and it's arguably a cleaner way
because now both the base address and offset are in the same file.

regards,
dan carpenter