Re: [PATCH v6 1/5] media: dt-bindings: Add CAMSS device for Kaanapali

[Vijay Kumar Tumati]

On 12/16/2025 7:29 PM, Bryan O'Donoghue wrote:
> On 17/12/2025 00:46, Vijay Kumar Tumati wrote:
> > > I don't understand a reason why to do worse for the upstream, when 
> > > there is
> > > a clear and feasible alternative not to do worse, thus my 
> > > misunderstanding
> > > and my grief for upstream CAMSS are my concerns.
> > Thanks for the comments, Vladimir. Bryan's and Krzysztof's argument 
> > was that the bindings are required to describe the full hardware 
> > regardless of the driver support and either way not modifiable in the 
> > future, so they preferred having the HW properties of the key 
> > functional blocks in the bindings. And we were specifically asked to 
> > add the properties into this node in this patch series. Having said 
> > that, my knowledge on how the bindings are handled upstream in the 
> > long run as the requirements evolve, is limited. So I will look for 
> > some expert advise from Bryan here as he strongly advised for these. 
> > Thanks again.
>
> I see no technical reason why describing the whole hardware block 
> precludes any further work. How could it ?
>
> Anyway, I'll repeat my ask to describe:
>
> - The full register set
> - The interconnects
> - The clocks and resets
> - The SIDs
>
> ---
> bod

Yes, it is what's been done. Assuming this thread is closed then.

Thanks,

Vijay.