[PATCH] idpf: increment completion queue next_to_clean in sw marker wait routine

[Li Li]

Currently, in idpf_wait_for_sw_marker_completion(), when an
IDPF_TXD_COMPLT_SW_MARKER packet is found, the routine breaks out of
the for loop and does not increment the next_to_clean counter. This
causes the subsequent NAPI polls to run into the same
IDPF_TXD_COMPLT_SW_MARKER packet again and print out the following:

    [   23.261341] idpf 0000:05:00.0 eth1: Unknown TX completion type: 5

Instead, we should increment next_to_clean regardless when an
IDPF_TXD_COMPLT_SW_MARKER packet is found.

Tested: with the patch applied, we do not see the errors above from NAPI
polls anymore.

Signed-off-by: Li Li <boolli@xxxxxxxxxx>
---
 drivers/net/ethernet/intel/idpf/idpf_txrx.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/intel/idpf/idpf_txrx.c b/drivers/net/ethernet/intel/idpf/idpf_txrx.c
index 69bab7187e541..4435dba27a24a 100644
--- a/drivers/net/ethernet/intel/idpf/idpf_txrx.c
+++ b/drivers/net/ethernet/intel/idpf/idpf_txrx.c
@@ -2346,14 +2346,14 @@ void idpf_wait_for_sw_marker_completion(const struct idpf_tx_queue *txq)
 		target = complq->txq_grp->txqs[id];
 
 		idpf_queue_clear(SW_MARKER, target);
-		if (target == txq)
-			break;
 
 next:
 		if (unlikely(++ntc == complq->desc_count)) {
 			ntc = 0;
 			gen_flag = !gen_flag;
 		}
+		if (target == txq)
+			break;
 	} while (time_before(jiffies, timeout));
 
 	idpf_queue_assign(GEN_CHK, complq, gen_flag);
-- 
2.52.0.351.gbe84eed79e-goog