Re: [PATCH v4 4/4] arm64: dts: qcom: Add base PURWA-IOT-EVK board

[Yijie Yang]

On 1/19/2026 3:05 PM, Krzysztof Kozlowski wrote:
> On 19/01/2026 04:13, Yijie Yang wrote:
> > On 1/17/2026 12:19 AM, Krzysztof Kozlowski wrote:
> > > On 16/01/2026 11:41, YijieYang wrote:
> > > > From: Yijie Yang <yijie.yang@xxxxxxxxxxxxxxxx>
> > > >
> > > > The PURWA-IOT-EVK is an evaluation platform for IoT products, composed of
> > > > the Purwa IoT SoM and a carrier board. Together, they form a complete
> > > > embedded system capable of booting to UART.
> > > >
> > > > PURWA-IOT-EVK uses the PS8833 as a retimer for USB0, unlike HAMOA-IOT-EVK.
> > > > Meanwhile, USB0 bypasses the SBU selector FSUSB42.
> > >
> > > NAK.
> > >
> > > Warnings were reported at v3. Did you address them? No, you completely
> > > ignored them, so warnings are reported again at v4.
> > >
> > > What do you think these emails are for?
> >
> > This warning is caused by the pcie3_phy node in purwa.dtsi, which is not
> > introduced by this patch set. Since it does not impact functionality,
>
> Your patchset introduces that warning. There was no such warning before.
>
> My NAK still stays, such patchset must not be merged.

This patch series can continue to be reviewed with the dependency noted, 
right?
https://lore.kernel.org/linux-arm-msm/20260119-topic-purwa_phy_shutup_warning-v1-1-997a692b31c6@xxxxxxxxxxxxxxxx/T/#u

> Best regards,
> Krzysztof

--
Best Regards,
Yijie