[PATCH v2 1/3] arm64: dts: imx93-9x9-qsb: change usdhc tuning step for eMMC and SD

[ziniu . wang_1]

From: Luke Wang <ziniu.wang_1@xxxxxxx>

During system resume, the following errors occurred:

  [  430.638625] mmc1: error -84 writing Cache Enable bit
  [  430.643618] mmc1: error -84 doing runtime resume

For eMMC and SD, there are two tuning pass windows and the gap between
those two windows may only have one cell. If tuning step > 1, the gap may
just be skipped and host assumes those two windows as a continuous
windows. This will cause a wrong delay cell near the gap to be selected.

Set the tuning step to 1 to avoid selecting the wrong delay cell.

For SDIO, the gap is sufficiently large, so the default tuning step does
not cause this issue.

Signed-off-by: Luke Wang <ziniu.wang_1@xxxxxxx>
---
 arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts b/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts
index 0852067eab2c..197c8f8b7f66 100644
--- a/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts
+++ b/arch/arm64/boot/dts/freescale/imx93-9x9-qsb.dts
@@ -507,6 +507,7 @@ &usdhc1 {
 	pinctrl-2 = <&pinctrl_usdhc1_200mhz>;
 	bus-width = <8>;
 	non-removable;
+	fsl,tuning-step = <1>;
 	status = "okay";
 };
 
@@ -519,6 +520,7 @@ &usdhc2 {
 	vmmc-supply = <&reg_usdhc2_vmmc>;
 	bus-width = <4>;
 	no-mmc;
+	fsl,tuning-step = <1>;
 	status = "okay";
 };
 
-- 
2.34.1