Re: [PATCH v3 1/4] arm64: dts: qcom: ipq9574: Add gpio details for eMMC

[Konrad Dybcio]

On 1/29/26 7:28 AM, Varadarajan Narayanan wrote:
> The RDP433 has NAND and eMMC variants. Presently, only NAND variant is
> supported. To enable support for eMMC variant, add the relevant GPIO
> related information.
> 
> Do not enable NAND by default here. Enable it in board specific DTS.
> 
> Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
> Signed-off-by: Varadarajan Narayanan <varadarajan.narayanan@xxxxxxxxxxxxxxxx>
> ---
> v3: Disable nand in ipq9574-rdp-common.dtsi and enable it where required.
>     Add 'Reviewed-by: Konrad Dybcio'
> ---

[...]

>  &qpic_bam {
> @@ -179,7 +211,7 @@ &qpic_nand {
>  	pinctrl-0 = <&qpic_snand_default_state>;
>  	pinctrl-names = "default";
>  
> -	status = "okay";
> +	status = "disabled";

This part should apply to the second patch, since you now broke NAND
for every board that had it running previously by disabling it in the
common DTSI and not immediately overriding it back.

This must not happen, since it impacts bisectability of the kernel tree

The solution is to squash this hunk above (not the addition of eMMC GPIOs)
with patch 3.

You can also drop the status=disabled in common.dtsi, since it's already
disabled in the SoC dtsi.

Konrad