[PATCH v5 3/4] dt-bindings: net: ethernet-phy: add property enet-phy-lane-polarity

[Damien Dejean]

Add the property enet-phy-lane-polarity to describe the polarity of the
PHY lanes. To ease PCB designs some manufacturers allow to wire the
pairs with a reverse polarity and provide a way to configure it.

The property 'enet-phy-lane-polarity' sets the polarity of each pair.
Bit 0 to 3 configure the polarity or pairs A to D, if set to 1 the
polarity is reversed for this pair.

Signed-off-by: Damien Dejean <dam.dejean@xxxxxxxxx>
---
 Documentation/devicetree/bindings/net/ethernet-phy.yaml | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 8347d4e134d2..67747493352b 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -132,6 +132,14 @@ properties:
     description:
       For normal (0) or reverse (1) order of the pairs (ABCD -> DCBA).
 
+  enet-phy-lane-polarity:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    maximum: 0xf
+    description:
+      A bitmap to describe pair polarity swap. Bit 0 to swap polarity of pair A,
+      bit 1 to swap polarity of pair B, bit 2 to swap polarity of pair C and bit
+      3 to swap polarity of pair D.
+
   eee-broken-100tx:
     $ref: /schemas/types.yaml#/definitions/flag
     description:
-- 
2.47.3