AW: [PATCH] mtd: nand: realtek-ecc: relax OOB size check to minimum

[markus.stockhausen]

> Von: Ahmed Naseef <naseefkm@xxxxxxxxx> 
> An: markus.stockhausen@xxxxxx
> Betreff: Re: [PATCH] mtd: nand: realtek-ecc: relax OOB size check to minimum
> ...
> > > Signed-off-by: Ahmed Naseef <naseefkm@xxxxxxxxx>
> > > Suggested-by: Markus Stockhausen <markus.stockhausen@xxxxxx>
> > 
> > IIRC this should be the other way round.
> > 
> Could you clarify what you meant by "the other way round" — do you
> mean the ordering of the Suggested-by/Signed-off-by tags, or the
> attribution itself?

The one who had the patch in his/her hands last, must be on the bottom 
of the list. Chronological order so to say.

> Regarding the comment about the two known devices — I was planning
> to update it to something like:

    * It can run for arbitrary NAND flash chips with different block and OOB sizes. Currently there
    * are a few known devices in the wild that make use of this ECC engine
    * (Linksys LGS328C, LGS352C & Netlink HG323DAC). To keep compatibility with vendor firmware,
    * new modes can only be added when new data layouts have been analyzed. For now allow BCH6 on
    * flash with 2048 byte blocks and at least 64 bytes oob. Some vendors make use of
    * 128 bytes OOB NAND chips (e.g. Macronix MX35LF1G24AD) but only use BCH6 and thus the first
    * 64 bytes of the OOB area. In this case the engine leaves any extra bytes unused.

Small adaptions fromm y side in the comment above. Check for spelling 
mistakes and line lengths. With this good to go from my side.

Markus