[PATCH v1 3/4] phy: phy-can-transceiver: Don't check for specific errors when parsing properties

[Andy Shevchenko]

Instead of checking for the specific error codes (that can be considered
a layering violation to some extent) check for the property existence first
and then either parse it, or apply a default value.

With that, return an error when parsing of the existing property fails.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
 drivers/phy/phy-can-transceiver.c | 14 +++++++++++---
 1 file changed, 11 insertions(+), 3 deletions(-)

diff --git a/drivers/phy/phy-can-transceiver.c b/drivers/phy/phy-can-transceiver.c
index dd08faf46837..ebce48ef217f 100644
--- a/drivers/phy/phy-can-transceiver.c
+++ b/drivers/phy/phy-can-transceiver.c
@@ -138,8 +138,9 @@ static int can_transceiver_phy_probe(struct platform_device *pdev)
 	struct gpio_desc *standby_gpio;
 	struct gpio_desc *enable_gpio;
 	struct mux_state *mux_state;
-	u32 max_bitrate = 0;
 	int err, i, num_ch = 1;
+	const char *propname;
+	u32 max_bitrate;
 
 	drvdata = device_get_match_data(dev);
 	if (drvdata->flags & CAN_TRANSCEIVER_DUAL_CH)
@@ -158,8 +159,15 @@ static int can_transceiver_phy_probe(struct platform_device *pdev)
 
 	priv->mux_state = mux_state;
 
-	err = device_property_read_u32(dev, "max-bitrate", &max_bitrate);
-	if ((err != -EINVAL) && !max_bitrate)
+	propname = "max-bitrate";
+	if (device_property_present(dev, propname)) {
+		err = device_property_read_u32(dev, "max-bitrate", &max_bitrate);
+		if (err)
+			return dev_err_probe(dev, err, "failed to parse %s\n", propname);
+	} else {
+		max_bitrate = 0;
+	}
+	if (!max_bitrate)
 		dev_warn(dev, "Invalid value for transceiver max bitrate. Ignoring bitrate limit\n");
 
 	for (i = 0; i < num_ch; i++) {
-- 
2.50.1