[PATCH v1 0/2] Add Lontiun LT7911EXC eDP to MIPI DSI bridge

[syyang]

From: Sunyun Yang <syyang@xxxxxxxxxxx>

The LT7911EXC is an I2C-controlled bridge that Receiver eDP1.4
and output signal/dual port mipi. This series introduces:

- A device tree binding YAML file describing the hardware
- A new DRM bridge driver implementing the basic functionality

Signed-off-by: Sunyun Yang<syyang@xxxxxxxxxxx>
---
Change in v1:
- dt-binding:
 1. reset pins use active low.                        [Dmitry]
- drm/bridge:
 1. use atomic_* callbacks.                           [Quentin]
 2. fix the incorrect formatting and spaces.
 3. add the required header files.                    [Dmitry]
 4. remove "enabled" flag.
 5. remove *fw from the lt7911exc struct.
 6. .max_register and .range_max use actual range.
 7. regulator use bulk interface.
 8. use dev_err_probe, devm_mutex_init and devm_drm_bridge_add.
 9. Replace GPL with GPL v2.
---
Sunyun Yang (2):
  dt-bindings:bridge: Add Lontiun LT7911EXC eDP to MIPI DSI bridge
  drm:bridge: Add Lontiun LT7911EXC eDP to MIPI DSI bridge

 .../display/bridge/lontium,lt7911exc.yaml     |  89 ++++
 drivers/gpu/drm/bridge/Kconfig                |  13 +
 drivers/gpu/drm/bridge/Makefile               |   1 +
 drivers/gpu/drm/bridge/lontium-lt7911exc.c    | 497 ++++++++++++++++++
 4 files changed, 600 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/display/bridge/lontium,lt7911exc.yaml
 create mode 100644 drivers/gpu/drm/bridge/lontium-lt7911exc.c

-- 
2.34.1