[PATCH 3/3] arm64: dts: renesas: rzt2h-n2h-evk: Enable xSPI nodes

[Prabhakar]

From: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>

Enable the xSPI0 and xSPI1 controllers on the RZ/T2H N2H EVK board.

The xSPI0 controller is connected to an MX25LW51245 octal flash device.
Although the hardware supports octal mode, configure the bus width to
1-bit (x1) mode. Enabling octal mode causes the BootROM to fail loading
the first-stage bootloader following a Watchdog Timer (WDT) reset.

The xSPI1 controller is connected to an AT25SF128A flash device.
Configure this interface for 4-bit (x4) mode to utilize the available
data lines.

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
---
 .../dts/renesas/rzt2h-n2h-evk-common.dtsi     | 135 ++++++++++++++++++
 1 file changed, 135 insertions(+)

diff --git a/arch/arm64/boot/dts/renesas/rzt2h-n2h-evk-common.dtsi b/arch/arm64/boot/dts/renesas/rzt2h-n2h-evk-common.dtsi
index f87c2492f414..0894c9d38971 100644
--- a/arch/arm64/boot/dts/renesas/rzt2h-n2h-evk-common.dtsi
+++ b/arch/arm64/boot/dts/renesas/rzt2h-n2h-evk-common.dtsi
@@ -5,6 +5,7 @@
  * Copyright (C) 2025 Renesas Electronics Corp.
  */
 
+#include <dt-bindings/clock/renesas,r9a09g077-cpg-mssr.h>
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/leds/common.h>
 #include <dt-bindings/net/mscc-phy-vsc8531.h>
@@ -20,6 +21,8 @@ aliases {
 		mmc0 = &sdhi0;
 		mmc1 = &sdhi1;
 		serial0 = &sci0;
+		spi0 = &xspi0;
+		spi1 = &xspi1;
 	};
 
 	chosen {
@@ -331,6 +334,59 @@ ctrl-pins {
 				 <RZT2H_PORT_PINMUX(17, 4, 0x29)>; /* SD1_CD */
 		};
 	};
+
+	xspi0_pins: xspi0-group {
+		clk-pins {
+			pinmux = <RZT2H_PORT_PINMUX(5, 1, 0x1c)>, /* XSPI0_CKP */
+				 <RZT2H_PORT_PINMUX(5, 2, 0x1c)>; /* XSPI0_CKN */
+			input-schmitt-disable;
+			slew-rate = <1>;
+			drive-strength-microamp = <9000>;
+		};
+
+		data-pins {
+			pinmux = <RZT2H_PORT_PINMUX(5, 6, 0x1c)>, /* XSPI0_IO0 */
+				 <RZT2H_PORT_PINMUX(5, 7, 0x1c)>, /* XSPI0_IO1 */
+				 <RZT2H_PORT_PINMUX(6, 0, 0x1c)>, /* XSPI0_IO2 */
+				 <RZT2H_PORT_PINMUX(6, 1, 0x1c)>, /* XSPI0_IO3 */
+				 <RZT2H_PORT_PINMUX(6, 2, 0x1c)>, /* XSPI0_IO4 */
+				 <RZT2H_PORT_PINMUX(6, 3, 0x1c)>, /* XSPI0_IO5 */
+				 <RZT2H_PORT_PINMUX(6, 4, 0x1c)>, /* XSPI0_IO6 */
+				 <RZT2H_PORT_PINMUX(6, 5, 0x1c)>; /* XSPI0_IO7 */
+			input-schmitt-disable;
+			slew-rate = <1>;
+			drive-strength-microamp = <9000>;
+		};
+
+		ctrl-pins {
+			pinmux = <RZT2H_PORT_PINMUX(5, 3, 0x1c)>, /* XSPI0_CS0 */
+				 <RZT2H_PORT_PINMUX(6, 6, 0x1c)>, /* XSPI0_RESET0 */
+				 <RZT2H_PORT_PINMUX(5, 5, 0x1c)>; /* XSPI0_DS */
+			input-schmitt-disable;
+			slew-rate = <1>;
+			drive-strength-microamp = <9000>;
+		};
+	};
+
+	xspi1_pins: xspi1-group {
+		ctrl-pins {
+			pinmux = <RZT2H_PORT_PINMUX(1, 0, 0x1c)>, /* XSPI1_CKP */
+				 <RZT2H_PORT_PINMUX(1, 1, 0x1c)>; /* XSPI1_CS0 */
+			input-schmitt-enable;
+			slew-rate = <1>;
+			drive-strength-microamp = <9000>;
+		};
+
+		data-pins {
+			pinmux = <RZT2H_PORT_PINMUX(1, 4, 0x1c)>, /* XSPI1_IO0 */
+				 <RZT2H_PORT_PINMUX(1, 5, 0x1c)>, /* XSPI1_IO1 */
+				 <RZT2H_PORT_PINMUX(1, 6, 0x1c)>, /* XSPI1_IO2 */
+				 <RZT2H_PORT_PINMUX(1, 7, 0x1c)>; /* XSPI1_IO3 */
+			input-schmitt-enable;
+			slew-rate = <1>;
+			drive-strength-microamp = <9000>;
+		};
+	};
 };
 
 &sci0 {
@@ -395,3 +451,82 @@ &wdt2 {
 	timeout-sec = <60>;
 };
 
+&xspi0 {
+	pinctrl-0 = <&xspi0_pins>;
+	pinctrl-names = "default";
+	status = "okay";
+
+	assigned-clocks = <&cpg CPG_CORE R9A09G077_XSPI_CLK0>;
+	assigned-clock-rates = <50000000>;
+
+	flash@0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		m25p,fast-read;
+		spi-tx-bus-width = <1>;
+		spi-rx-bus-width = <1>;
+		vcc-supply = <&reg_3p3v>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition@0 {
+				label = "bl2-0";
+				reg = <0x00000000 0x00060000>;
+				read-only;
+			};
+
+			partition@1fb000 {
+				label = "fip-0";
+				reg = <0x00060000 0x007a0000>;
+				read-only;
+			};
+
+			partition@300000 {
+				label = "user-0";
+				reg = <0x800000 0x003800000>;
+			};
+		};
+	};
+};
+
+&xspi1 {
+	pinctrl-0 = <&xspi1_pins>;
+	pinctrl-names = "default";
+	status = "okay";
+
+	assigned-clocks = <&cpg CPG_CORE R9A09G077_XSPI_CLK1>;
+	assigned-clock-rates = <50000000>;
+
+	flash@0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		m25p,fast-read;
+		spi-tx-bus-width = <4>;
+		spi-rx-bus-width = <4>;
+		vcc-supply = <&reg_3p3v>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition@0 {
+				label = "bl2-1";
+				reg = <0x00000000 0x00060000>;
+			};
+
+			partition@60000 {
+				label = "fip-1";
+				reg = <0x00060000 0x007a0000>;
+			};
+
+			partition@800000 {
+				label = "user-1";
+				reg = <0x800000 0x800000>;
+			};
+		};
+	};
+};
-- 
2.54.0