[PATCH] drivers: altera_edac: Fix OCRAM ECC init for warm reset

[muhammad . nazim . amirul . nazle . asmade]

From: Nazim Amirul <muhammad.nazim.amirul.nazle.asmade@xxxxxxxxxx>

The OCRAM ECC is always enabled either by the BootROM or by the
Secure Device Manager (SDM) during a power-on reset on SoCFPGA.

However, during a warm reset, the OCRAM content is retained to
preserve data, while the control and status registers are reset to
their default values. As a result, ECC must be explicitly re-enabled
after a warm reset.

Signed-off-by: Niravkumar L Rabara <nirav.rabara@xxxxxxxxxx>
Signed-off-by: Nazim Amirul <muhammad.nazim.amirul.nazle.asmade@xxxxxxxxxx>
---
 drivers/edac/altera_edac.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/edac/altera_edac.c b/drivers/edac/altera_edac.c
index 103b2c2eba2a..9e6a9786a881 100644
--- a/drivers/edac/altera_edac.c
+++ b/drivers/edac/altera_edac.c
@@ -1186,8 +1186,14 @@ altr_check_ocram_deps_init(struct altr_edac_device_dev *device)
 
 	/* Verify OCRAM has been initialized */
 	if (!ecc_test_bits(ALTR_A10_ECC_INITCOMPLETEA,
-			   (base + ALTR_A10_ECC_INITSTAT_OFST)))
-		return -ENODEV;
+			   (base + ALTR_A10_ECC_INITSTAT_OFST))) {
+		if (!ecc_test_bits(ALTR_A10_ECC_EN,
+				   (base + ALTR_A10_ECC_CTRL_OFST)))
+			ecc_set_bits(ALTR_A10_ECC_EN,
+				     (base + ALTR_A10_ECC_CTRL_OFST));
+		else
+			return -ENODEV;
+	}
 
 	/* Enable IRQ on Single Bit Error */
 	writel(ALTR_A10_ECC_SERRINTEN, (base + ALTR_A10_ECC_ERRINTENS_OFST));
-- 
2.43.7