Re: [PATCH v4] arm64: dts: qcom: monaco-arduino-monza: Add QCNFA725B WiFi support

[Dmitry Baryshkov]

On Tue, Jun 02, 2026 at 03:03:00PM +0800, Qian Zhang wrote:
> On Tue, Jun 2, 2026 at 11:32 AM Qian Zhang <qian.zhang@xxxxxxxxxxxxxxxx> wrote:
> >
> > On Mon, Jun 1, 2026 at 8:39 PM Dmitry Baryshkov
> > <dmitry.baryshkov@xxxxxxxxxxxxxxxx> wrote:
> > >
> > > On Mon, Jun 01, 2026 at 07:46:49PM +0800, Qian Zhang wrote:
> > > > On Sun, May 31, 2026 at 5:09 PM Dmitry Baryshkov
> > > > <dmitry.baryshkov@xxxxxxxxxxxxxxxx> wrote:
> > > > >
> > > > > On Sun, May 31, 2026 at 12:44:09PM +0530, Qian Zhang wrote:
> > >
> > > > > > +
> > > > > > +     wcn6855-pmu {
> > > > > > +             compatible = "qcom,wcn6855-pmu";
> > > > > > +
> > > > > > +             pinctrl-names = "default";
> > > > > > +             pinctrl-0 = <&wlan_en_state>;
> > > > > > +
> > > > > > +             wlan-enable-gpios = <&tlmm 56 GPIO_ACTIVE_HIGH>;
> > > > >
> > > > > No bt-enable-gpios?
> > > > BT is enabled in node uart10
> > > > https://lore.kernel.org/all/20260429103537.1282497-1-shuai.zhang@xxxxxxxxxxxxxxxx/
> > >
> > > The BT is powered on by this PMU. So, if you are adding PMU, it should
> > > be used by the BT node too.
> > >
> > Will move bt_en from uart10 to here.
> >
> > Thanks,
> > Qian
> >
> enable-gpios in uart10 is required by qcom,qca2066-bt.yaml
> and cannot be removed to PMU.

Then fix the schema (and the driver).

> 
> Thanks,
> Qian
> > > > >
> > > > > > +
> > > > > > +             vddio-supply    = <&vdc_3v3>;
> > > > >
> > >
> > > --
> > > With best wishes
> > > Dmitry

-- 
With best wishes
Dmitry