Re: [PATCH v1] usb: typec: ucsi: Pass full DP config payload in SET_NEW_CAM for DP alt mode

[Greg KH]

On Fri, Jun 19, 2026 at 08:33:29PM +0530, madhu.m@xxxxxxxxx wrote:
> From: Madhu M <madhu.m@xxxxxxxxx>
> 
> In the UCSI Specification Revision 3.1 RC1, bits 32-63 of the SET_NEW_CAM
> command hold the 32-bit Alternate Mode Specific (AMSpecific) field.
> 
> For DisplayPort Alternate Mode, this field must contain the full
> 32-bit DisplayPort configuration VDO payload that the OPM wants the
> connector to operate in, rather than just the pin assignment value.
> This AMSpecific value follows the DisplayPort Configurations defined
> in the DisplayPort Alt Mode on USB Type-C Specification v2.1a,
> Table 5-13: SOP DisplayPort Configurations.
> 
> Signed-off-by: Madhu M <madhu.m@xxxxxxxxx>
> Reviewed-by: Jameson Thies <jthies@xxxxxxxxxx>
> Reviewed-by: Andrei Kuchynski <akuchynski@xxxxxxxxxxxx>
> Reviewed-by: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx>
> ---
>  drivers/usb/typec/ucsi/displayport.c | 3 +--
>  1 file changed, 1 insertion(+), 2 deletions(-)
> 
> diff --git a/drivers/usb/typec/ucsi/displayport.c b/drivers/usb/typec/ucsi/displayport.c
> index 67a0991a7b76..2e3d7c734d9f 100644
> --- a/drivers/usb/typec/ucsi/displayport.c
> +++ b/drivers/usb/typec/ucsi/displayport.c
> @@ -185,13 +185,12 @@ static int ucsi_displayport_status_update(struct ucsi_dp *dp)
>  
>  static int ucsi_displayport_configure(struct ucsi_dp *dp)
>  {
> -	u32 pins = DP_CONF_GET_PIN_ASSIGN(dp->data.conf);
>  	u64 command;
>  
>  	if (!dp->override)
>  		return 0;
>  
> -	command = UCSI_CMD_SET_NEW_CAM(dp->con->num, 1, dp->offset, pins);
> +	command = UCSI_CMD_SET_NEW_CAM(dp->con->num, 1, dp->offset, dp->data.conf);
>  
>  	return ucsi_send_command(dp->con->ucsi, command, NULL, 0);
>  }
> -- 
> 2.34.1
> 
> 

SHouldn't this have a Fixes: and cc: stable tag?

thanks,

greg k-h