[PATCH 1/3] scsi: ufs: ufs-qcom: Restore TX Equalization settings on FOM failure

[Can Guo]

ufs_qcom_get_rx_fom() applies temporary device TX Equalization values
before forcing HS mode and running the EOM-based SW FOM scan.

When one of these steps fails, the function can bypass the shared
cleanup path and leave temporary TX Equalization settings programmed.

Route those failures through the cleanup label so the original TX EQ
settings are restored and link recovery runs before exit.

This path also reuses ret for cleanup, so it may overwrite the original
error. Keep that on purpose: if cleanup succeeds, the caller can proceed
with the FOM result for the current iteration.

Signed-off-by: Can Guo <can.guo@xxxxxxxxxxxxxxxx>
---
 drivers/ufs/host/ufs-qcom.c | 9 ++++-----
 1 file changed, 4 insertions(+), 5 deletions(-)

diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
index c084ccc72523..7d7c001435bf 100644
--- a/drivers/ufs/host/ufs-qcom.c
+++ b/drivers/ufs/host/ufs-qcom.c
@@ -2791,7 +2791,7 @@ static int ufs_qcom_get_rx_fom(struct ufs_hba *hba,
 	if (ret) {
 		dev_err(hba->dev, "%s: Failed to apply TX EQ settings for HS-G%u: %d\n",
 			__func__, gear, ret);
-		return ret;
+		goto link_recover_and_restore;
 	}
 
 	/* Force PMC to target HS Gear to use new TX Equalization settings. */
@@ -2799,16 +2799,15 @@ static int ufs_qcom_get_rx_fom(struct ufs_hba *hba,
 	if (ret) {
 		dev_err(hba->dev, "%s: Failed to change power mode to HS-G%u, Rate-%s: %d\n",
 			__func__, gear, ufs_hs_rate_to_str(rate), ret);
-		return ret;
+		goto link_recover_and_restore;
 	}
 
 	ret = ufs_qcom_host_sw_rx_fom(hba, pwr_mode->lane_rx, fom);
-	if (ret) {
+	if (ret)
 		dev_err(hba->dev, "Failed to get SW FOM of TX (PreShoot: %u, DeEmphasis: %u): %d\n",
 			d_iter->preshoot, d_iter->deemphasis, ret);
-		return ret;
-	}
 
+link_recover_and_restore:
 	/* Restore Device's TX Equalization settings. */
 	ret = ufshcd_apply_tx_eq_settings(hba, &hba->tx_eq_params[gear - 1], gear);
 	if (ret) {
-- 
2.34.1